Team:Brown-Stanford/REGObricks/Balloon

From 2011.igem.org

(Difference between revisions)
Line 19: Line 19:
== '''Balloon Flights''' ==
== '''Balloon Flights''' ==
-
===='''The Sand Column'''====
 
-
 
-
We attempted to create a macroscopic demonstration of biocementation. Upon learning that the biocementation process was of sufficient value and difficulty to warrant two separate patent applications for elucidating the process, we tried to separately elucidate the process for iGEM’s open resource community. Following the guidance of several research articles, we built several cementation columns. Materials and procedures can be found '''[https://2011.igem.org/Team:Brown-Stanford/Lab/Protocols/CementationColumn here]'''
 
-
 
-
[[File:Brown-Stanford-Columngetup.JPG|thumb|200px|Setup of Cementation Column]]
 
-
 
-
Unfortunately, construction of a flow-through cementation column was unsuccessful, though we did manage to create surface-layer biocementation on petri dishes. Cementation after 5 days proved sufficiently stiffened enough to resist a scalpel. Disappointment aside, we learned that it had taken the researchers over six years to master the process, and that we went against high odds to replicate it in three months.
 
-
 
-
[[File:Brown-Stanford-Moonghettobrick.JPG|300px|thumb|Two Dimensional Cementation of Lunar Regolith Simulant]]
 
-
 
-
As compensation for our plight, one of the visiting researchers with a pending patent for biocementation allowed us fly one of the real cemented bricks in our weather-balloon trip to the edge of the world to see how the drastic reductions in temperature and pressure will affect the brick and bacteria.
 
-
 
-
[[File:Brown-Stanford-Flyingbrick.JPG|300px|thumb|Preflight CT Scan of Biocemented Brick]]
 
===='''Survival in Extremophile conditions- Balloon Launches'''====
===='''Survival in Extremophile conditions- Balloon Launches'''====
Line 43: Line 30:
Thorough Protocols for the preparation can be found [https://2011.igem.org/Team:Brown-Stanford/Lab/Protocols/BalloonFlight#Preparation_of_Samples_for_Balloon_Flight: here]
Thorough Protocols for the preparation can be found [https://2011.igem.org/Team:Brown-Stanford/Lab/Protocols/BalloonFlight#Preparation_of_Samples_for_Balloon_Flight: here]
-
[[File:Brown-Stanford-Earthstratosphere.JPG|300px|thumb|Overlooking the Curvature of the Earth]]
 
Our balloon went up to 80,000 ft (24 kilometers), from which the curvature of the earth was visible.  
Our balloon went up to 80,000 ft (24 kilometers), from which the curvature of the earth was visible.  

Revision as of 16:06, 28 September 2011

Brown-Stanford
iGEM

Balloon Flights

Survival in Extremophile conditions- Balloon Launches

Working at NASA Ames, we had the good fortune of meeting Jack Cackler, who was trying to prototype small balloon launches to the stratosphere. Located at 10 to 50 kilometers above the ground, the stratosphere has conditions that are out of this world: a temperature range of -56 to -3°C (it actually increases as you ascend, from chemical synthesis of ), and atmosphere 0.001 percent of that of earth’s sea level. To take advantage of this rare opportunity, we prepared two dried samples of S. pasteurii to be sent up in the balloon, to test the ability of the bacteria to withstand the extremes in temperature, depressurization and radiation bombardment. Note that the microbes we flew were not genetically altered.

Materials for the Stratospheric Balloon Flight

Thorough Protocols for the preparation can be found here

Our balloon went up to 80,000 ft (24 kilometers), from which the curvature of the earth was visible.

Qualitative Survival Analysis after Balloon Flight
Qualitative Survival Analysis after Balloon Flight

Unfortunately, our S. pasteurii cargo, as well as all other cargo, did not survive the first flight. During our second flight (accompanied by the BBC ), we prepared the S. pasteurii inside [http://www.enasco.com/c/whirlpak/Whirl-Pak%26%23174%3B+Bags/ Whirlpak bags]. Surprisingly enough, upon retrieval, the the samples inside the Whirlpak bags exhibited urease activity! The ones outside the bags did not, though mysteriously enough both samples grew back on Bang media plates in seemingly equal quantities. Further experimentation must be done to ascertain the exact nature of the survival.

Our original grand plan was to have one final balloon flight, after our transformation of S. pasteurii with Newcastle 2009’s sporulation regulation gene, to see if induced sporulation could have increase the percentage of survivors. Unfortunately, difficulties in transforming S. pasteurii put this this plan on hold.