Team:Bielefeld-Germany/Modell

From 2011.igem.org

Revision as of 20:21, 15 September 2011 by Jaretz (Talk | contribs)

Modelling of intracellular bisphenol A degradation

The modelling was done with the software [http://www.berkeleymadonna.com/ Berkeley Madonna] using the [http://en.wikipedia.org/wiki/Runge–Kutta_methods#Common_fourth-order_Runge.E2.80.93Kutta_method common fourth-order Runge-Kutta] method to solve the equations. The model was fitted to the measured data by the function "curve fit" in Berkeley Madonna to calculate the parameters, constants etc.

To model the BPA degradation by E. coli carrying BioBricks for BPA degradation (<partinfo>K123000</partinfo> and <partinfo>K123001</partinfo>) the cell growth has to be described first. The observed growth of E. coli on (our) LB medium was [http://en.wikipedia.org/wiki/Diauxie diauxic] with two different growth phases. Cell growth is a [http://en.wikipedia.org/wiki/First_order_kinetics#First-order_reactions first-order reaction] and is mathematically described as


Bielefeld-Germany2011-growth.png
(1)


with the specific growth rate µ and the cell count X. The specific growth rate is dependent on the concentration of the growth limiting substrate (e.g. glucose) and can be described as


Bielefeld-Germany2011-growthrate.png
(2)


with the substrate concentration S, the Monod constant KS and the maximal specific growth rate µmax ([http://www.annualreviews.org/doi/abs/10.1146/annurev.mi.03.100149.002103 Monod, 1949]). Because LB medium is a complex medium we cannot measure the substrate concentration so we have to assume an imaginary substrate concentration. Due to the diauxic growth two different substrates with different Monod constants and consumption rates are necessary to model the cell growth. The amount of a substrate S can be modelled as follows


Bielefeld-Germany2011-substrate.png
(3)


with the specific substrate consumption rate per cell qS. The whole model for the diauxic growth of E. coli on LB medium with two not measurable (imaginary) substrates looks like:


Bielefeld-Germany2011-model-ecoligrowth.png
(4)


The specific BPA degradation rate per cell qD is modelled with an equation like eq. (3). In the beginning of the cultivations, when E. coli growths on the "good" imaginary substrate S1, no BPA degradation is observed. When this substrate is consumed, the BPA degradation starts. The model for this diauxic behavior is as follows:


Bielefeld-Germany2011-model-ecoliBPA.png
(5)


Fig. 1 shows a comparison between modelled and measured data for cultivations with BPA degrading E. coli. In Tab. 1 the parameters for the model are given obtained by curve fitting the model to the data.


Fig. 1: Comparison between modelled (lines) and measured (dots) data for cultivations of E. coli KRX carrying BPA degrading BioBricks. The BioBricks K525512 (polycistronic bisdAB genes behind medium strong promoter, shown in black) and K525517 (fusion protein between BisdA and BisdB, expressed with medium strong promoter, shown in red) were cultivated at least five times in E. coli KRX in LB + Amp + BPA medium at 30 °C, using 300 mL shaking flasks without baffles with silicon plugs. The BPA concentration (closed dots) and the cell density (open dots) is plotted against the cultivation time.

Tab. 1: Parameters of the model.

Parameter K525512 K525517
X0 0.112 108 mL-1 0.138 108 mL-1
µmax 1.253 h-1 1.357 h-1
KS,1 2.646 AU-1 1.92 AU-1
KS,2 265.1 AU-1 103.1 AU-1
S1,0 1.688 AU 1.166 AU
qS,1 0.478 AU 10-8 cell-1 0.319 AU 10-8 cell-1
S2,0 16.091 AU 6.574 AU
qS,2 0.295 AU 10-8 cell-1 0.191 AU 10-8 cell-1
BPA0 0.53 mM 0.53 mM
qD 8.76 10-11 mM cell-1 1.29 10-10 mM cell-1

The specific BPA degradation rate per cell qD is about 50 % higher when using the fusion protein compared to the polycistronic bisdAB gene. This results in an average 9 hours faster, complete BPA degradation by E. coli carrying <partinfo>K525517</partinfo> compared to <partinfo>K525512</partinfo> as observed during our cultivations. The fusion protein between BisdA and BisdB improves the BPA degradation by E. coli.


References

Monod J (1949) The growth of bacterial cultures, Annu Rev Microbiol [http://www.annualreviews.org/doi/abs/10.1146/annurev.mi.03.100149.002103 3:371-394].