"

From 2011.igem.org

Modelling of intracellular bisphenol A degradation

To model the BPA degradation by E. coli carrying BioBricks for BPA degradation (<partinfo>K123000</partinfo> and <partinfo>K123001</partinfo>) the cell growth of has to be described first. The observed growth of E. coli on (our) LB medium was [http://en.wikipedia.org/wiki/Diauxie diauxic] with two growth phases. Cell growth is in general described as

dX/dt = µ * X

with the specific growth rate µ and the cell count X. The specific growth rate is dependent on the concentration of the growth limiting substrate (e.g. glucose) and can be described as

µ = µ_max S / (K_S + S)

with the substrate concentration S, the Monod constant K_S and the maximal specific growth rate µ_max. Because LB medium is a complex medium we cannot measure the substrate concentration so we have to assume an imaginary substrate concentration. Due to the diauxic growth two different substrates are necessary to model the cell growth. The amount of a substrate S can be modelled as follows

dS/dt = q_S * X

with the specific substrate consumption rate per cell q_S. The whole model for the diauxic growth of E. coli on LB medium with two not measurable (imaginary) substrates looks like:

{Growth}

init x = x₀

x₀ = 0.133

dX/dt = µ * X

µ = if S₁ >= 0.01 then µ_max * S₁ / (K_S,1 + S₁) else µ_max * S₂ / (K_S,2 + S₂)

µ_max = 1.24

K_S,1 = 10

K_S,2 = 138.7

limit µ >= 0

limit X >= 0

{Substrate 1}

init S₁ = S_1,0

S_1,0 = 6

dS₁/dt = -q_S,1 * X

q_S,1 = 1.4

limit S₁ >= 0

{Substrat 2}

init S₂ = S_2,0

S_2,0 = 10

dS₂/dt = if S₁ >= 0.01 then 0 else -q_S,2 * X

q_S,2 = 0.32

limit S₂ >= 0

The specific BPA degradation rate per cell q_D is modelled with a Michaelis-Menten like kinetics. In the beginning of the cultivations, when E. coli growths on the imaginary substrate S₁, there is no BPA degradation observed so the model looks like as follows:

{BPA degradation}

init BPA = BPA₀

BPA₀ = 0.53

dBPA/dt = if S₁ >= 0.01 then 0 else -q_D * X

q_D = q_D,max * BPA / (K_BPA + BPA)

q_D,max = 0.013

K_BPA = 1.6e-8

limit BPA >= 0

The modelling was done with the software [http://www.berkeleymadonna.com/ Berkeley Madonna] using [http://en.wikipedia.org/wiki/Runge–Kutta_methods#Common_fourth-order_Runge.E2.80.93Kutta_method common fourth-order Runge-Kutta] method to solve the equations.