From 2011.igem.org

Revision as of 17:46, 20 September 2011

S-layer

Molecular nanotechnology, especially nanobiotechnology starts to use and modify functionalized surfaces. Especially the immobilization of self-assembling biomolecules draws an increasing attention. The advantages of using immobilized enzymes in well-defined positions on nano-structured surfaces may even be greater. Self-assembly is an organization of molecules into defined structures, lowering the free energy of the system. Interaction between the molecules is non-covalent (e.g. hydrophobic-hydrophobic, van der Waals forces, molecular stacking) ([http://onlinelibrary.wiley.com/doi/10.1002/smll.200700200/abstract Schäffer et al., 2007]).

Many biomolecules such as protein, polysaccharides and lipid have the ability to self-assemble into different shapes (e.g. spherical, rod- or sheet-like shapes), allowing several specific functions as virus capsids, cytoskeleton components or extracellular surface layer protein. The so-called paracrystalline cell surface-layer (S-layer) are build up on S-layer proteins and are one of the most common surface structures in bacteria and archaea. They are regarded as the outmost cell envelope of prokaryotic organisms ([http://onlinelibrary.wiley.com/doi/10.1111/j.1574-6968.2006.00573.x/full Sleytr et al., 2007]).

S-layer in general

S-layer proteins fulfill various functions as molecular sieves, ion traps and protective coats ([http://onlinelibrary.wiley.com/doi/10.1002/3527600035.bpol7011/abstract Sleytr et al., 2005]). They build up periodic structures, posses pores of identical size and morphology and show equal physicochemical properties on each molecular unit. Isolated they have the special ability to reassemble into two-dimensional crystals equal to structures found on intact bacterial cells. S-layers have the ability to form self-assembly products in solution and to recrystallize into monomolecular layers on solid supports, at air-water interface and on lipid films. They can cover liposomes and nanocapsules als well as small beads completely. S-layer are mainly composed of a single (glyco)protein species, assembled into a layer completely covering the cell. In organisms the may represent up to 20% of the total protein content of a bacterial cell. Most S-layer proteins are weak acidic (pI 4-6) and contain a high proportion of hydrophobic amino acids as well as few or no sulphur-containing amino acids, their molecular mass varies between 40 – 200 kDa and is often strain-specific. The assembled S-layer lattices are generally 5 – 20 nm thick, in archaea lattices are up to 70 nm thick. The protein subunits of S-layer are arranged in lattices with different symmetry; olique (p1, p2), square (p4) or hexagonal (p3, p6) with a center-to-center spacing of the subunits of 3 – 35 nm. S-layer are highly porous with a porosity of 30 – 70% ([http://onlinelibrary.wiley.com/doi/10.1111/j.1742-4658.2006.05606.x/abstract Sleytr et al., 2007]).

Various S-layer proteins from archaea and eubacteria are glycosylated, with strain-specific modifications. S-layer proteins were the first prokaryotic proteins that were shown to exhibit this remarkable characteristic. Up until now glycosylation has been proven for several archaeal S-layer proteins. Among the bacterial species glycosylation was demonstrated only for S-layer proteins of Bacillaceae ([http://onlinelibrary.wiley.com/doi/10.1046/j.1365-2958.1997.d01-1868.x/abstract Chami et al., 1997], [http://onlinelibrary.wiley.com/doi/10.1002/smll.200700200/abstract Schäffer et al., 2007]).

In gram-negative archaea, S-layer are the exclusive cell wall component. In gram-positive bacteria and archaea, S-layer assemble on the outmost part of a firm wall matrix, which is composed mostly of peptidoglycan, pseudomurein. In gram-negative bacteria, S-layer are linked to specific lipopolysaccharides (LPS) ([http://onlinelibrary.wiley.com/doi/10.1002/3527600035.bpol7011/abstract Sleytr et al., 2005]). For gram-positive bacteria a cell-wall-targeting domain could be identified at the N-terminal end of many S-layer proteins. The domain facilitates binding to a specific secondary cell wall polymer (SCWP) by a lectin-type binding ([http://onlinelibrary.wiley.com/doi/10.1111/j.1742-4658.2006.05606.x/abstract Sleytr et al., 2007]). It was found that some S-layer proteins consist of two distinct domains with different functions. One domain ist involved in the assembly with other S-layer protein monomers and the other domain mediates the interaction with the cell wall. Several SLH domains have been identified at the amino-terminal region of different S-layer proteins and at the carboxy-terminal region of cell-assiociated exoroteins. The domain may be repeated within the sequence and is involved in anchoring the S-layer proteins to the cell surface ([http://onlinelibrary.wiley.com/doi/10.1046/j.1365-2958.1997.d01-1868.x/abstract Chami et al., 1997], [http://www.sciencedirect.com/science/article/pii/S0966842X99015139 Sleytr & Beveridge, 1999]). In various S-layer proteins from bacillacaea the deletion of significant parts of the carboxy-terminal or amino-terminal did not affect self-assembly and the capability of the S-layer proteins to form lattices ([http://onlinelibrary.wiley.com/doi/10.1111/j.1742-4658.2006.05606.x/abstract Sleytr et al., 2007]).

The supramolecular structure as well as the mechanism of binding the outmost cell wall vary between S-layers of different species, leading to the development different isolation procedures. S-layers normally are attached to the cell wall through non-covalent binding, and can therefore be isolated and completely disintegrated in dissociating agents (e.g. lithium chloride), metal-chelating agents (e.g. ethylendiaminetetraacetic acid EDTA), chaotropic denaturants such as urea or guanidine hydrochloride and by raising or lowering pH. After removal of the disrupting agent reassembly takes place. ([http://onlinelibrary.wiley.com/doi/10.1002/3527600035.bpol7011/abstract Sleytr et al., 2005]).

The S-layer protein PS2 of Corynbacterium glutamicum

The S-layer of the Gram-positive bacterium Corynebacterium glutamicum ATCC 17965 is formed by the PS2 protein. The protein is encoded by the cspB gene. The mature protein has a molecular mass of 52.5 kDa. It is devoid of any sulfur-containing amino acids, whereas its nature is due to a high content of hydrophobic amino acids. Although there exist a lot of different S-layer proteins, PS2 has no similarities to any other protein in the EMBL database. The S-layer of C. glutamicum is characterized by a hexagonal lattice symmetry. Attachment between S-layer and cell wall was found to be due to the hydrophobic carboxy-terminus of the PS2 protein. It was found that peptidoglycan is probably not involved in interaction between the PS2 S-layer and the cell because the interaction between PS2 and the cell is disrupted by adding detergents. Also the S-layer protein from C. glutamicum does not contain a SLH domain, which is characteristic for several S-layer proteins and other enzymes bound to the peptidoglycan. Besides some other S-layer proteins show a carboxy-terminal hydrophobic sequence of 20 – 24 amino acids. (e.g. Halobacterium halobium, Haloferax volcanii, Rickettsia rickettsii)([http://onlinelibrary.wiley.com/doi/10.1046/j.1365-2958.1997.d01-1868.x/abstract Chami et al., 1997], [http://www.sciencedirect.com/science/article/pii/S016816560400241X Hansmeier et al., 2004]).

The S-layer protein SgsE of

References

Chami M, Bayan N, Peyret JL, Gulik-Krzywicki T, Leblon G, Shechter E (1997) The S-layer protein of Corynebacterium glutamicum is anchored to the cell wall by its C-terminal hydrophobic domain, [http://onlinelibrary.wiley.com/doi/10.1046/j.1365-2958.1997.d01-1868.x/abstract Mol Microbiol. 23(3):483-92.]

Hansmeier N, Bartels FW, Ros R, Anselmetti D, Tauch A, Pühler A, Kalinowski J (2004) Classification of hyper-variable Corynebacterium glutamicum surface-layer proteins by sequence analyses and atomic force microscopy [http://www.sciencedirect.com/science/article/pii/S016816560400241X J Biotechnol. 26;112(1-2):177-93.]

Schäffer C, Novotny R, Küpcü S, Zayni S, Scheberl A, Friedmann J, Sleytr UB, Messner P (2007) Novel biocatalysts based on S-layer self-assembly of Geobacillus stearothermophilus NRS 2004/3a: a nanobiotechnological approach, [http://onlinelibrary.wiley.com/doi/10.1002/smll.200700200/abstract Small 3(9):1549-59.]

Sleytr UB, Beveridge TJ (1999) Bacterial S-layers. [http://www.sciencedirect.com/science/article/pii/S0966842X99015139 Trends Microbiol. 7(6):253-60.]

Sleytr UB, Sára M, Pum D, Schuster B, Messner P, Schäffer C (2005) Self-assembling protein systems: microbial S-layers, in: [http://onlinelibrary.wiley.com/doi/10.1002/3527600035.bpol7011/abstract Steinbüchel A, Fahnestock SR (Eds.), Polyamides 34 and complex proteinaceous materials, Wiley-VCH, Weinheim, pp. 285-338.]

Sleytr UB, Egelseer EM, Ilk N, Pum D, Schuster B (2007) S-Layers as a basic building block in a molecular construction kit, [http://onlinelibrary.wiley.com/doi/10.1111/j.1574-6968.2006.00573.x/full FEBS J 274(2):323-34]

Sleytr UB, Huber C, Ilk N, Pum D, Schuster B, Egelseer EM (2007) S-layers as a tool kit for nanobiotechnological applications, [http://onlinelibrary.wiley.com/doi/10.1111/j.1574-6968.2006.00573.x/full FEMS Microbiol Lett. 267(2):131-44.]