Team:ETH Zurich/Process/Validation

From 2011.igem.org

(Difference between revisions)

Revision as of 10:44, 23 October 2011

Can you feel the smoke tonight?

Final Setup and Evaluation

Experimental Setup

Results

Analysis

This page presents a biological experiment which showed that the setup of the flow channel works as predicted by the models (compare plots in the modeling section).

Channel construction with a technique photolithography

To construct our final channel, we used the technique photolithography. Photolithography is the photopatterning of channels from a mask (drawing of channels in 2D) and is based on the utilization of particular substances (photoresists) that become soluble to particular solvents after being exposed to UV light [1].

@BIOLOGISTS: I need some information about how exactly you constructed the channel. can you ask Olivier maybe to give you some proticols? I can then write them down. Can you also take a look at the reference? Is this what you did? Thanks

References: [1] http://www.elveflow.com/microfluidic/16-start-with-microfluidics

@@ Line 17: / Line 17: @@
 To construct our final channel, we used the technique photolithography. Photolithography is the photopatterning of channels from a mask (drawing of channels in 2D) and is based on the utilization of particular substances (photoresists) that become soluble to particular solvents after being exposed to UV light [1].
-'''
-@BIOLOGISTS:  I need some information about how exactly you constructed the channel. can you ask Olivier maybe to give you some proticols? I can then write them down. Can you also take a look at the reference? Is this what you did? Thanks'''
+'''@BIOLOGISTS:  I need some information about how exactly you constructed the channel. can you ask Olivier maybe to give you some proticols? I can then write them down. Can you also take a look at the reference? Is this what you did? Thanks'''