Team:Arizona State/Notebook/PCRLog

From 2011.igem.org

(Difference between revisions)
Line 56: Line 56:
==Primer Round 2==
==Primer Round 2==
-
==Primer Round 3==
+
==Primer Round 3 (CasABCDE only)==
 +
===August 4, 2011===
 +
<p><b>Settings</b>: 98 initial denaturation for 30 seconds, Cycle (10sec at 98deg, anneal 30 sec at 63 deg, elongate 130sec at 72deg), 35 Cycles, Extension for 450 seconds</p>
 +
[[Image:]]
 +
<br>Results show a band above where we think it ought to be (6 to 8 kbp instead of 4.3)
 +
However, this was extracted and an attempt at a nested PCR was made using the same settings to try and amplify this band even further. The results were blank.
 +
===August 8, 2011===
 +
<p><b>Settings</b>:ABCDE808, which is same as 8/4 run but only 29 cycles in the hope that the bright band from the previous try would be the only one visible.</p>
 +
[[Image:]]
 +
<br>Looks very similar to previous results. Again, a band above where we would like to see it.
 +
 +
===August 8, 2011===
 +
<p><b>Settings</b>: Retry same protocol in thermocycler, however increase back to 35 cycles.</p>
 +
[[Image:]]
 +
<br>Not as good as the original run, though there may be faint bands where we would like to see them. For some reason the brightest band is again somewhere between 6k and 8k (though it's a bit hard to tell because the ladder curves annoyingly at the top), instead of the desired 4300. However, we have ordered the nested PCR primers, so perhaps that will offer a better solution to getting Cas ABCDE. In the meantime, we'll focus again on Cas3 and try to extract that and get a good sequencing result so we can say definitively that we have it.
 +
 +
===August 10, 2011 (Evening)===
 +
<p><b>Settings</b>: Ran another PCR for ABCDE, same settings as before but one degree higher for annealing temp. Also added DMSO.</p>
}} <!-- close content attribute for menubar -->
}} <!-- close content attribute for menubar -->

Revision as of 22:01, 28 September 2011


PCR Log for E. Coli Cas Genes


ASU Logo.png

Overview

This logbook is a record of the majority of our attempts to PCR amplify CRISPR-associated (Cas) ABCDE and Cas 3 of E. coli K12 MG1655. The record begins after our attempt to individually PCR amplify each of the 6 genes, which was unsuccessful. Here, three different sets of primers were used to attempt PCR amplification of the Cas genes in two sections.

Notes

Suggested annealing temperatures are based on [http://www.neb.com/nebecomm/tech_reference/TmCalc/Default.asp NEB Tm Calculator], as called for in the [http://www.neb.com/nebecomm/tech_reference/polymerases/phusion_high.asp?&utm_source=Google&utm_medium=CPC&utm_term=+phusion&utm_campaign=Phusion NEB Phusion DNA Polymerase] protocol.

Desired band for CasABCDE at ~4300bp

Desired band for Cas3 at ~2667bp

Primer Round 1

July 17, 2011

CasABCDE: Touchdown PCR, Start Temp 70, -0.2 / cycle, Final Temp 64
Cas3: Touchdown PCR, Start Temp 63, -0.2 / cycle, Final Temp 57

Gel Results:

ASU 717 cas gel.jpg
CasABCDE: Very faint bands near target length
Cas3: No bands

July 18, 2011

CasABCDE: Touchdown PCR, Start Temp 65, -0.2 / cycle, Final Temp 59

Gel Results:


CasABCDE: No bands

July 19, 2011

CasABCDE: Touchdown PCR, Start Temp 70, -0.2 / cycle, Final Temp 63
Cas3: Temp gradient with 3 rows from 72 to 55 (L to R: 55, 61.7, 71)
Gel Results:
ASU 719 casABCDE.jpg
CasABCDE: Clearer bands around target length, primer dimers
ASU 719 cas3.jpg
Cas3: Middle temperature was optimal, clear bands are visible (likely correct length, failed to run a hyperladder), primer dimers

July 20, 2011

CasABCDE: Touchdown PCR, Start Temp 71, -0.2 / cycle, Final Temp 64
Cas3: Gradient using tighter range around best temp from yesterday (65.6, 63.1, 61.2, 58.5)

Gel Results:

[[Image:]]
CasABCDE: Nonspecific, nothing usable, no bands in target range, dimerization [[Image:]]
Cas3: Small band at correct location, primer dimers

July 24, 2011

PCR of CasABCDE, Cas3 with new settings; Preparation for extraction, "PCRception" (PCRing the PCR results); Included an elongation step in each cycle, which was not done for the previous runs; Settings stored in PCR machine as ABCDE724, CAS3724

CasABCDE Settings and Results:
[[Image:]]
[[Image:]]
Nonspecific results, perhaps a hint of the correct bands in the second to last well
Cas3 Settings and Results:
[[Image:]]
[[Image:]]
Success for Cas3!! Extracted the band that lies around ~2500 (target is 2600). However, sequencing results were never conclusive and the sample was lost.

Primer Round 2

Primer Round 3 (CasABCDE only)

August 4, 2011

Settings: 98 initial denaturation for 30 seconds, Cycle (10sec at 98deg, anneal 30 sec at 63 deg, elongate 130sec at 72deg), 35 Cycles, Extension for 450 seconds

[[Image:]]
Results show a band above where we think it ought to be (6 to 8 kbp instead of 4.3) However, this was extracted and an attempt at a nested PCR was made using the same settings to try and amplify this band even further. The results were blank.

August 8, 2011

Settings:ABCDE808, which is same as 8/4 run but only 29 cycles in the hope that the bright band from the previous try would be the only one visible.

[[Image:]]
Looks very similar to previous results. Again, a band above where we would like to see it.

August 8, 2011

Settings: Retry same protocol in thermocycler, however increase back to 35 cycles.

[[Image:]]
Not as good as the original run, though there may be faint bands where we would like to see them. For some reason the brightest band is again somewhere between 6k and 8k (though it's a bit hard to tell because the ladder curves annoyingly at the top), instead of the desired 4300. However, we have ordered the nested PCR primers, so perhaps that will offer a better solution to getting Cas ABCDE. In the meantime, we'll focus again on Cas3 and try to extract that and get a good sequencing result so we can say definitively that we have it.

August 10, 2011 (Evening)

Settings: Ran another PCR for ABCDE, same settings as before but one degree higher for annealing temp. Also added DMSO.