Team:Washington/Protocols/Gib Rxn
From 2011.igem.org
Gibson Cloning Protocol
Materials Needed
- 5X isothermal (ISO) reaction buffer (25% PEG-8000, 500 mM Tris-HCl pH 7.5, 50 mM MgCl2, 50 mM DTT, 1 mM each of the 4 dNTPs, and 5 mM NAD). This is prepared as described below.
- T5 exonuclease (Epicentre)
- Phusion DNA polymerase (New England Biolabs)
- Taq DNA ligase (New England Biolabs)
Equipment
1. Heat block or thermocycler with PCR tubes.
Procedure
- Prepare 5X ISO buffer. Six ml of this buffer can be prepared by combining the following:
- 3 ml of 1 M Tris-HCl pH 7.5
- 150 μl of 2 M MgCl2
- 60 μl of 100 mM dGTP
- 60 μl of 100 mM dATP
- 60 μl of 100 mM dTTP
- 60 μl of 100 mM dCTP
- 300 μl of 1 M DTT
- 1.5 g PEG-8000
- 300 μl of 100 mM NAD
- Add water to 6 ml
- Aliquot 100 μl and store at -20 °C
- Prepare an assembly master mixture. This can be prepared by combining the following:
- 320 μl 5X ISO buffer
- 0.64 μl of 10 U/ μl T5 exo
- 20 μl of 2 U/μl Phusion pol
- 160 μl of 40 U/μl Taq lig
- Add water to 1.2 ml
- Aliquot 15 μl and store at -20 °C. This assembly mixture can be stored at -20 °C for at least one year. The enzymes remain active following at least 10 freeze-thaw cycles.
- This is ideal for the assembly of DNA molecules with 20-150 bp overlaps. For DNA molecules overlapping by larger than 150 bp, prepare the assembly mixture by using 3.2 μl of 10 U/ μl T5 exo.
- Thaw a 15 μl assembly mixture aliquot and keep on ice until ready to be used.
- Add 5 μl of DNA to be assembled to the master mixture. The DNA should be in equimolar amounts. Use 10-100 ng of each ~6 kb DNA fragment. For larger DNA segments, increasingly proportionate amounts of DNA should be added (e.g. 250 ng of each 150 kb DNA segment).
- Incubate at 50 °C for 15 to 60 min (60 min is optimal).
- If cloning is desired, electroporate 1 μl of the assembly reaction into 30 μl electrocompetent E. coli.