• Introduction
  • Home
  • The Team
  • Photo Gallery
• Our Project
  • Results Summary
  • Selection System
  • In-Vitro Characterization
  • In-Vivo Characterization
  • Microfluidics
  • Data
  • Attributions
• Tools
  • Gibson Assembly
  • MITOMI
• Notebook
  • Protocols
  • May
  • June
  • July
  • August
  • September
  • October
• Considerations
  • Human Practices
  • Safety
• Acknowledgements
  • Sponsors
  • Partners

Linear template- TetR

Two step extension PCR

Materials

• 10µl 5x iProof HF buffer
• 0.5 µl of each primer
• 1 µl dNTP mix of 10mM
• 0.5 µl High Fidelity Polymerase
• 1 µl DNA template
• 36.5 µl H2O

Protocol

• Put mix in PCR thermal cycler
• Program the PCR thermal cycler: 1. 98°C for 30s 2. 98°C for 7.5 seconds 3. 58°C for 20 sec (this depends on the primers, therefore look up the annealing temperature of the primers used) 4. 72°C you have to calculate the time required. This polymerase has an effciency of 15-30s/kb. (calculate for the longest fragment) 6. 72°C for 5 min 7. 4°C "forever"
• Save the file in the MAIN folder→ OK→ SAVE→RUN→Select the block you use→ RUN→ Change sample volume to 50µl, LidT should be 105°C and the box just below ("hotlid") should ALWAYS be checked
• Press STATUS to check the progress