DNA Synthesis
Gel Extraction (QIAquick)
- Excise DNA fragment from agarose gel with clean, sharp scalpel.
- Weigh gel slice in colorless tube. Add 3 volumes of Buffer QG to 1 volume of gel (100mg ~ 100µl)
- Incubate @ 50C for 10 min.
- SOLUBILIZE AGAROSE COMPLETELY.
- To help dissolve gel, vortex tube every 2-3 min during incubation.
- After the gel has dissolved, check that the color of the mixture is yellow. If not, add 10µl 3M NaOAc. Or just add the NaOAc anyway.
- Add 1 gel volume of isopropanol to the sample and mix
- Do only if <500bp or >4kb
- Place spin column in 2mL collection tube.
- To bind DNA, apply sample to column. Centrifuge 1 min.
- Discard flowthrough and place column back in same collection tube.
- Recommended: Add 0.5mL of Buffer QG to column and centrifuge for 1 min.
- To wash, add 0.75mL of Buffer PE to column and centrifuge for 1 min.
- Discard flowthrough and centrifuge for an additional 1 min @ 17900 x g (13000rpm).
- Place column into a clean 1.5mL microcentrifuge tube.
- To elute DNA, add 30µL Buffer EB to center of membrane, let column stand for 1 min, then centrifuge for 1 min.
Mini-Prep (QIA)
- Resuspend pelleted bacterial cells in 250 µL Buffer P1 and transfer to a microcentrifuge tube.
- Add 250 µL Buffer P2 and mix thoroughly by inverting the tube 4-6 times.
- Add 350 µL Buffer N3 and mix immediately and thoroughly by inverting the tube 4-6 times.
- Centrifuge for 10 min at 13,000 rpm in a table-top microcentrifuge.
- Apply the supernatants from step 4 to the QIAprep spin column by decanting or pipetting.
- Centrifuge for 30-60s. Discard the flow-through.
- Recommended: Wash the QIAprep spin column by adding 0.5 mL Buffer PB and centrifuging for 30-60s. Discard flow-through.
- Wash QIAprep spin column by adding 0.5 mL Buffer PB and centrifuging 30-60s.
- Discard flow-through and centrifuge for an additional minute to remove residual wash bufffer. **IMPORTANT: Residual wash buffer will not be completly removed unless the flow-through is discarded before this additional centrifugation. Residual ethanol from Buffer PE may inhibit subsequent enzyme reactions.**
- Ordered List ItemPlace QIAprep column in a clean 1.5 mL microcentrifuge tube. To elute DNA, add 50 µL Buffer EB (10mM Tris-CL, pH 8.5) or water to the center of each QIAprep spin column, let stand for 1 min, and centrifuge for 1 min.
Synthesis
Overlap Extension
In order to assemble our Vitamin C genes, we used overlap extension PCR. Oligos of up to 60 bp were ordered from IDT, sequentially, in building blocks of up to 800 bp. The first oligo had a 40 base pair overlap with the next, and so on, until the end of that particular chunk of the gene, called a building block. GDP L-Galactose Phosphatase and GDP Mannose-3,5-Epimerase both are made up of two building blocks, and L-Galactose 1-phosphate phosphatase is composed of only one building block. This process is known as templateless PCR. Following this, the PCR product (which will include both incomplete building blocks and a small amount of final product) is PCR amplified using the first and last oligos. This step is called finishing PCR. These building blocks are then purified using a zymogen DNA purification column and then assembled into the final construct in the vector via a CPEC reaction.
CPEC
(Quan 2009)
- Measure the DNA concentration of each assembly piece
- Assay 100ng of the linearized vector backbone and equimolar amounts of the other assembly pieces to a 25ul total volume assembly reaction mi#xture accordingly:
- 100 ng of vector backbone
- equimolar ammounts of each assembly piece
- 5ul 5X HF Phusion Buffer
- 1ul 10mM dNTPs
- 0.75ul DMSO
- 0.5ul 2U/ul Phusion Polymerase
- H2O to 25ul
- Perform the assembly reaction in a thermocycler as follows:
Temperature | Time | Cycles |
98C | 3 min | 1 |
98C | 30 sec | 15 * |
55C | 30 sec | 15 * |
72C | total length(kb) * 15 sec | 15 * |
72C | 10 min | 1 |
- Note: the number of repeated cycles should exceed the number of assembly pieces
- Transform 5ul of the assembly reaction into 100ul of competent E. coli and/or run a diagnostic agarose gel to check for successful assembly.
DNA Assay