Team:EPF-Lausanne/Protocols/Master microfabrication for PDMS replica molding
From 2011.igem.org
(Difference between revisions)
Line 1: | Line 1: | ||
{{:Team:EPF-Lausanne/Templates/ProtocolHeader|title=Master fabrication for PDMS replica molding}} | {{:Team:EPF-Lausanne/Templates/ProtocolHeader|title=Master fabrication for PDMS replica molding}} | ||
- | + | The protocol below is for a two lithographic steps process, for the case when two different channel heights are needed. | |
- | + | If one height is needed, as in the case of MITOMI chips fabrication, only one resist configured during one lithographic process is necessary. | |
+ | Cross section images of the wafer during the main technological steps | ||
[[File:Microchannel fabrication steps - 1.png]] | [[File:Microchannel fabrication steps - 1.png]] | ||
+ | [[File:Microchannel fabrication steps - 2.png]] | ||
{{:Team:EPF-Lausanne/Templates/Footer}} | {{:Team:EPF-Lausanne/Templates/Footer}} |
Revision as of 20:07, 21 September 2011
Master fabrication for PDMS replica molding
Back to protocols.The protocol below is for a two lithographic steps process, for the case when two different channel heights are needed. If one height is needed, as in the case of MITOMI chips fabrication, only one resist configured during one lithographic process is necessary. Cross section images of the wafer during the main technological steps