From 2011.igem.org

Revision as of 21:29, 17 September 2011

Module 1: Phyto-Route

Chemotaxis is the movement of bacteria based on attraction or repulsion of chemicals. Roots secrete a variety of compounds that E. coli are not attracted to naturally. Accordingly, we engineered a chemoreceptor into our chassis that can sense malate, a common root exudate, so that it can swim towards the root. Additionally, E. coli are actively taken up by plant roots, which will allow targeted IAA delivery into roots by our system.

Testing

The assembled construct PA2652 (BBa_K515102) and non codon optimised mcpS in pRK415, have been inserted and tested for functioning in E. coli DH5α obtained from New England Biolabs. The tests have tried to show the rewired chemotaxis towards L (-) malic acid. We have separated testing of chemotaxis towards malate into qualitative, quantitative and behavioral analyses. One factor concerning the assays, which was severely underestimated at the start of the testing stage, but was quickly realised, was the difficulty of performing a functional assay to obtain results. Testing of the functionality of our construct has therefore involved an enormous number of changes and troubleshooting modifications, just to find out that further changes were needed for a functioning assay.

To test bacterial uptake into the roots of the plants we were working with Arabidopsis thaliana to observe the uptake of bacteria into plant roots. A. thaliana is a common plant model organism. It belongs to the mustard family and fulfils many important requirements for model organism. As such, its genome has been almost completely sequenced and replicates quickly, producing a large number of seeds. It is easily transformed and many different mutant strains have been constructed to study different aspects (National Institute of Health, no date). While Arabidopsis may not represent plant populations naturally occurring in arid areas threatened by desertification, it is a handy model organism we will be using to study the effect of auxin on roots, observe chemotaxis towards them and look at uptake of bacteria into the roots.

Qualitative analysis

Qualitative assays should inform us about positive or negative result of rewiring chemotaxis in E. coli with engineered construct mcpS or PA2652 (BBa_K515102). However it does not inform us about the cell count and the extent to which engineered bacteria can chemotax towards the attractant source.

A number of methods exist that show chemotaxis towards a source (1). Most of them are based on the properties of semi - solid agar, which allows diffusion of molecules and bacterial movement. We have modified agar plug assay to to observe chemotactic response. The bacteria used were in mid - exponential phase (OD₆₀₀ 0.4 - 0.6). Cells suspended in the semi solid agar were left overnight to grow and move. At the end of the assay the plates were imaged using Fujifilm LAS-3000 Imager.

DH5-α Escherichia coli cells were used as studied subject expressing our construct. Negative control used were cells without engineered construct, with selection marker for ampicillin and kanamycin. This was to show inability of the non - engineered cells to perform chemotaxis towards malate. Positive control used were cells without engineered construct, with selectable marker for kanamycin and ampicillin. The attractant used to test positive control was serine a chemical, which is recognised by native chemoreceptors of E. coli. This was to show that cells we are using to conduct our experiments have functional chemotaxis pathway and are capable of recognising an attractant gradient.The tested DH5-α Escherichia coli contained construct (BBa_K515102) PA2652 malate chemoreceptor.We have also tested cells containing non-codon optimised mcpS gene carried on pRK415 plasmid with selectable tetracycline. However due to the lack of information about the construct, and the fact that it is non - standard biobrick format, with several illegal restriction sites within the sequence, we did not test this construct further analyses.

Results expected from this assay should show clear differences in shape of the formed colony, since the bacteria attracted to source will move and therefore distort the shape of the colony into eliptical, directed shape towards the source, in comparison with control, which expected to look circular as bacteria are equally likely to swim into any direction.

Table 1: The concentrations of attractant tested

Positive control

Figure 1: Rising concentrations of serine were tested. a) 0 M control - circular colony b) 10^-5 M - circular colony e) 10 ^-4 M - circular colony d) 10 ^-3 M - possible eliptical colony c) 10 ^-2 M - eliptical colony f) 10 ^-1 M - eliptical colony away from the attractant.

Figure 2: Rising concentrations of serine were tested. a) 0 mM control - circular colony, b)5 mM - eliptical colony c) 10 mM - eliptical colony d) 15 mM - eliptical colony e) 20 mM - eliptical colony f) 25mM - circular colony.

Negative control

Figure 2: Rising concentrations of malate were tested. a) 0 M control - circular colony b) 10^-5 M - circular colony c) 10 ^-4 M - circular colony d) 10 ^-3 M - circular colony e) 10 ^-2 M - circular colony f) 10 ^-1 M - circular colony.

Figure 2: Rising concentrations of malate were tested. a) 0 M control - circular colony b)5 mM - circular colony c) 10 mM - circular colony d) 15 mM - circular colony e) 20 mM - circular colony, f) 25mM - circular colony.

McpS - pRK415

Figure 2: Rising concentrations of malate were tested. a) 0 M control - circular colony b) 10^-5 M - circular colony c) 10 ^-4 M - circular colony d) 10 ^-3 M - circular colony e) 10 ^-2 M - circular colony f) 10 ^-1 M - circular colony.

Figure 2: Rising concentrations of serine were tested. a) 0 mM control - circular colony b)5 mM - circular colony c) 10 mM - eliptical colony formed not in the direction expected d) 15 mM - possible eliptical colony e) 20 mM - possible eliptical colony f) 25mM - circular colony.

PA2652 - BBa_K515102

Figure 2: Rising concentrations of malate were tested. a) 0 M control - circular colony b) 10^-5 M - possible eliptical colony the shape is hard to analyze c) 10 ^-4 M - strange shape of colony observed, however this was not a result of mishandling with semi - solid agar d) 10 ^-3 M - colony shape is not perfectly circular however not eliptical either e) 10 ^-2 M - circular colony f) 10 ^-1 M - circular colony.

Figure 2: Rising consentrations of serine were tested. a) 0 mM control - circular colony b)5 mM - colony shape was rendered void due to mishandling with semi - solid agar c) 10 mM - circular colony d) 15 mM - eliptical shape of the colony is not in the direction of the attractant e) 20 mM - colony shape was rendered void due to mishandling with semi - solid agar f) 25mM - circular colony.

The data obtained from this assay were not easily analysed. This assay is qualitative and therefore should provide us with positive or negative result. However upon analysis of the data a conclusion can not be drawn. This is because, set up of the assay gives space for ambiguity. This is due to a number of factors. Attractant is localised, and it diffuses to all directions, however the plate is not infinite and therefore loss of concentration gradient occurs over time. Another factor is the semi - solid agar itself. This medium is relatively difficult to manipulate with and a number of samples were ruined during the handling. Even considering that set up of this assay lead to vague results a number of points can be drawn. Positive control have shown that E. coli DH5α are capable of chemotaxis. It has also shown that when added attractant is of too high concentration (10^-1 M) bacteria do not swim directly towards the attractant source since the medium around the source is saturated. Instead they perform chemotaxis in a direction, where the attractant concentration gradient is set up, so that it is in the range for sensing by chemoreceptors. This occurs even if it means that the bacteria effectively move away from the attractant source. Negative control have shown that at any tested concentration of L (-) malic acid E. coli DH5α without PA2652 or mcpS construct do not perform chemotaxis towards attractant show. The assay have, however failed to conclude a result for mcpS or PA2652 construct as the colonies observed have a range of shapes at different attractant concentrations, that do not allow us to conclude positive or negative result.

Quantitative Analysis

In comparison to qualitative assays, quantitative assays are more informative as they provide cell count based on different attractant concentrations and therefore allow identification of the optimal attractant concentration for bacterial chemotaxis. Our analyses were based on the high throughput capillary assay (2). We have modified this assay to obtain cell count through flow cytometer in contrast to commonly used CFU count. The assay itself is based on a number of capillaries filled with different concentrations of attractant placed into bacterial suspension for a period of 30 minutes. Even though the assay itself sounds simple, the set up was proven to be very difficult to lead us to obtain any data.

Figure 9: High through-put capillary assay

Behavioral analysis

Video 1: Mixed population of GFP expressing control and non GFP labelled PA2652 expressing E. coli.

2. Tests for uptake of bacteria into roots

Wednesday, 3 August 2011

One important part of our project is uptake of our bacteria into plant roots. The observation that this occurs (albeit under controlled lab settings) is new and was only published last year. We attempted to replicate these findings.

In preparation, we met with Dr Martin Spitaler who advised us on how to prepare samples for the confocal microscopy. Confocal microscopy is much more precise than conventional light field microscopy as it eliminates background light by focusing the laser through a pinhole (Mark Scott, oral communication). The confocal microscopy will focus on imaging GFP expressing bacteria inside Arabidopsis roots to show that uptake of the bacteria takes place.

Staining of wt roots with DiD, a lipophilic dye that stains the plant membranes and does not interfere with the absorption or emission spectra of GFP and Dendra, was unsuccessful. However, natural fluorescence was measured in a root in a spectrum that does not interfere with measuring GFP. We should therefore not need to dye the roots before imaging.

Stack of wt Arabidopsis root. The root can be imaged at around 488nm. Imaging carried out by Dr Martin Spitaler.

We may also try to stain the roots with propidium iodide, which is also a strong indicator of cell wall break down.

Thursday, 4 August 2011

We prepared the GFP-expressing bacteria for plant infection. They were spun down and media was exchanged prior to incubation at 37°C to reach exponential phase. Bacteria were then spun down and resuspended in wash buffer (5mM MES) to reach OD 30. 8ml, 4ml and 2ml were added to separate flasks, containing 100ml of half-MS media each. 4ml and 6ml of wash buffer were added to the flasks containing 4ml and 2ml bacteria, respectively. 8ml of wash buffer was added to the negative control. Ten Arabidopsis seedlings were distributed into each of the flasks. Incubation was carried out for 15 hours prior to imaging.

Friday, 5 August 2011

Prior to imaging, roots were washed in PBS to wash off bacteria and facilitate imaging. We imaged the plants incubated with 8ml of bacteria and were able to find bacteria inside one of the roots. A 3D picture was taken of uninfected roots and roots containing bacteria by taking a Z stackk image using confocal microscopy.

This video shows an image put together from successive images taken at different depth levels. The GFP-expressing bacteria are clearly visible within the root.

We also imaged roots that did not contain bacteria via a similar Z-stack scan. This image is shown below.

We repeated this experiment at a later date with plants that had been allowed to grow for a longer period of time. The bacteria were predominantly found in root hairs and inside of cells on the root surface.

3. Tracking of cell viability using Dendra

Dendra-expressing bacteria were also taken up into plant roots. Using a confocal microscope, we photoconverted the Dendra protein from green to red fluorescence. Conversion with the 405nm laser was completed after about 15 rounds of bleaching at 50% laser intensity with the pinhole set to 3 airy units.

Dendra photoconversion in bacteria taken up inside plant roots. 1 is the area photoconverted using the 405nm laser. 2 is an individual bacterium whose Dendra protein has undergone photoconversion. 3 is a negative control consisting of a non-photoconverted bacterium. The bacteria found inside the roots can be seen on the right. The data on the left displays the conversion from green to red fluorescence for the highlighted areas. Ch2: emission in green spectrum. Ch3: emission in red spectrum. ChD: brightfield emission.

References

(1) Jain*, R.K., & Pandey, J. (2010) Chemotactic Responses. V K. N. Timmis, ed. Handbook of Hydrocarbon and Lipid Microbiology. Berlin, Heidelberg: Springer Berlin Heidelberg, pp. 3933-3955. Available at: http://www.springerlink.com/content/x458521h8420l478/ [Cited September 16, 2011].

(2) Bainer, R., Park, H. & Cluzel, P. (2003) A high-throughput capillary assay for bacterial chemotaxis.Journal of Microbiological Methods, 55, pp. 315 - 319.

Retrieved from "http://2011.igem.org/Team:Imperial_College_London/Project_Chemotaxis_Testing"