Model1

iGEM UT-Tokyo

Model1: L-Asp diffusion

Aim

We needed to know the behavior of L-Asp diffusion to perform our entire simulation (model3). We experimentaly researched Asp diffusion using TLC method but the results were insufficient for the entire simulation. So we decided to investigate the Asp diffusion by numerical simulation.

Method

We estimated the value of diffusion coefficient by interpolating molecular mass of L-Asp (133) from the relationship between molecular weight and diffusion constant as shown in figure 1^[1].

Figure 1. Molecular Weight v.s. Diffusion Constant (1% agar. gel)

The estimated value was D = 0.001 [mm²/sec]. We used 0.25% agar gel in our experiment and according to a paper^[2], there is no practical difference of diffusion coefficient between 1% and 0.25% agar gel.

We simulated the time development of the L-Asp concentration distribution. We simulated the diffusion equation using 1st order finite difference method.

A indicates the L-Asp concentration and D means the diffusion coefficient. The shape of system was a circle with radius 5cm. We dropped 2×10^-7 mol Asp at the center of the circle as the initial state.

Result

The time change of logarithmic values of L-Asp concentration at 2, 6, 8 mm from the center is shown in figure 3.

Figure 3. Change in L-Asp Concentration Over Time (2, 6, 8 mm from the center)

References