Team:Paris Bettencourt/T7 diffusion

From 2011.igem.org

(Difference between revisions)
Line 35: Line 35:
<center>
<center>
-
<img src="https://static.igem.org/mediawiki/2011/9/99/T7_diffusion.jpg" />
+
<img src="https://static.igem.org/mediawiki/2011/9/99/T7_diffusion.jpg" width=600px/>
</p><b><u>Fig2:</u></b> Schematic summarizing the T7 diffusion device</p>
</p><b><u>Fig2:</u></b> Schematic summarizing the T7 diffusion device</p>
</center>
</center>

Revision as of 12:49, 20 September 2011

Team IGEM Paris 2011

The T7 RNA polymerase design

Bacteriophage T7 RNA polymerase is a DNA-dependant RNA polymerase from the T7 bacteriophage genome. The enzyme is composed of a single polypeptide chain of 880 amino acids. It catalyzes the processive polymerization of messenger RNA from nucleoside triphosphate precursors by using one strand of DNA as a template . This enzyme is known to have a stringent specificity for its promoter, that is orthogonal to the other promoter of the cell.

In our designs, we wanted a protein to pass through the tubes and trigger a signal in the receiver cell. We see here that T7 RNA polymerase is a very good candidate for such systems. That's why we used it as the biggest of our proof of principle molecules.

            

Fig1: Cristallographic structure of RNA polymerase. (source)

Making the T7 RNA polymerase diffuse through the tubes

Calculating the radius of the T7 RNA polymerase we noticed that it is smaller than the average size of the nanotubes we can measure from the Ben-Yehuda paper. So we made the assumption that such a big molecule has a chance to pass through the tubes, and we started building the design.

  • In the emittor cell, we have to over express the T7 polymerase for them to have a chance to pass through the tube. As we said in the general overview the production of T7 polymerase is over the control of an IPTG inducible promoter design to have a slow response by the over-expression of LacI in the cell. The RFP, placed on the same mRNA, is behaving like a reporter of the quantity of the produced T7 polymerase.
  • In the receiver cell, a system, sensitive to the T7 polymerase will be activated if one T7 polymerase reaches its promoter, present in a few plasmids of the receiver cell (low copy). The system is self amplifying and the GFP is produced as a monitor of the signal.

    • The principle of the design is summed up in the image below


    Fig2: Schematic summarizing the T7 diffusion device

    T7 polymerase as a good quality auto-amplifier

    One of our first concern was the potential leakage from the auto amplifier. We are in biological systems, that is to say a noisy system. The promoter is known to be very orthogonal from the one of the endogenic polymerase. However, we had to deal with several problems. We invite you to see the experiments page for data about these problems we faced.

    As we were not working in a synthetic biology plasmid (we designed our own multi host vector), designed to be silent, we had to add several stop before the promoters.

    As an alternative solution, we also constructed a GFP with a T7 promoter. This system is supposed to have a lower response, but at least there would be only very few leakage

    Model and experiments

    To know more about what we have done on this system and in the experiments, we invite you to visit the corresponding modeling and experiment pages:



    Retrieved from "http://2011.igem.org/Team:Paris_Bettencourt/T7_diffusion"