Team:Paris Bettencourt/Experiments/Methodologies/Tecan

From 2011.igem.org

(Difference between revisions)
m
Line 25: Line 25:
We usually organized our plate as below.<br>
We usually organized our plate as below.<br>
[[File:Tecan_nanotube_plate_Paris.jpg|center]]
[[File:Tecan_nanotube_plate_Paris.jpg|center]]
 +
 +
We realized so much wells with a ratio 1:1 to get the closest possible to the conditions of the article.
<br><br><br>
<br><br><br>

Revision as of 23:15, 28 October 2011

Team IGEM Paris 2011

What we call the Tecan is the Infinite 200 PRO multimode reader from Tecan®.

Tecan Picture Paris.jpg

This machine can read fluorecence and absorbance in a 96 well plate, within cycles that are programmed to be repeated, and the kinetics can last for hours. It allows to look at evolution of fluorescence during all the growth of a bacterial colony.

In our case as the receiver end the emitter of each of our system has a specific fluorescence, we tuned the Tecan to measure fluorescence every 5 or 10 minutes for 3 to 12 hours depending on what we were studying. Indeed to characterize a part we do the characterization overnight when if we wanted to do a nanotube experiment it had to last for the exponential phase of B. subtilis and 3 to 4 hours were enough.
The advantage of the tecan over the other techniques is the quantification of the fluorescence observed.

Nanotube experiment

What we wanted to measure with the Tecan is the appearance of fluorescence from the switch on of the receiver system. But to switch on the receiver system we needed the conditions of the nanotube experiment to be reproduced in the 200 microliter well of the 96 plate. we first tested the growth of GFP+ Bacillus subtilis in three different conditions to see if they could grow normally, the conditions were :

  • cells in rich media (LB) centrifuged
  • cells in rich media, with on the bottom of the well a thin layer of LB agar, centrifuged
  • cells in rich media without centrifugation

Our controls were LB without bacterias, and LB agar and LB without bacterias. We tuned the Tecan for it to measure at the good level even when there was agar in the bottom and ran the experiment for 12 hours. At the end of the 12 hours we resuspended the cells and measured the optical density to be able to compare if the cells grew approximatively the same according to the conditions.

Curves GFP+ Paris.jpg

According to the curve the LB agar wasn't important for the cell's growth.

We then realized in parallel of the microscopy team all the experiments they were doing with the same systems, but as we had 96 wells to do so we tried different ratios of strains. For each ratio we did at least a triplicate.
We usually organized our plate as below.

Tecan nanotube plate Paris.jpg

We realized so much wells with a ratio 1:1 to get the closest possible to the conditions of the article.