Team:EPF-Lausanne/Tools/Microfluidics/HowTo2

From 2011.igem.org

(Difference between revisions)
(Details of connections)
(Details of connections)
Line 40: Line 40:
== Details of connections ==
== Details of connections ==
-
 
-
[[File:EPFL-Setup.png|thumb|right|Annotated picture of the fluidics setup. The role of each component is explained. Not shown: since the picture was taken, manometers were added to the pressure regulators.]]
 
Below are three images detailing how the tubing and electronics in our setup are connected, and the role of each component.
Below are three images detailing how the tubing and electronics in our setup are connected, and the role of each component.
Line 47: Line 45:
A printed circuit board (PCB) is used to connect the solenoid valves to the relays on the easyDAQ, and power them. The solenoids are connected to the PCB via two flat cables, one soldered to the red wires, one soldered to the black wires (they are 14-wire cables, with two wires removed). The other end of each cable is fitted with a 14-pin connector. The PCB is powered by a 24 V power supply, and distributes the power to each solenoid through the relays on the EasyDAQ. Therefore, when a relay is open, a 24 V load is applied to the corresponding solenoid (wich opens it). When the relay is closed, both leads of the solenoid are grounded (which closes it).
A printed circuit board (PCB) is used to connect the solenoid valves to the relays on the easyDAQ, and power them. The solenoids are connected to the PCB via two flat cables, one soldered to the red wires, one soldered to the black wires (they are 14-wire cables, with two wires removed). The other end of each cable is fitted with a 14-pin connector. The PCB is powered by a 24 V power supply, and distributes the power to each solenoid through the relays on the EasyDAQ. Therefore, when a relay is open, a 24 V load is applied to the corresponding solenoid (wich opens it). When the relay is closed, both leads of the solenoid are grounded (which closes it).
-
[[File:EPFL-PCB.png|thumb|left|Close-up of the PCB that connects the valves to the EasyDAQ.]]
+
[[File:EPFL-Setup.png|thumb|right|150px|Annotated picture of the fluidics setup. The role of each component is explained. Not shown: since the picture was taken, manometers were added to the pressure regulators.]]
-
[[File:EPFL-relay_schematic.jpg|thumb|left|How the solenoids are switched between ground and 24 V by the relays. Only shown for four relays; our setup has twelve connected identically.]]
+
[[File:EPFL-PCB.png|thumb|left|150px|Close-up of the PCB that connects the valves to the EasyDAQ.]]
-
[[File:EPFL-EasyDAQ.jpg|thumb|left|The EasyDAQ: 24 USB-controlled relays. The relays are connected to the PCB just by wires fixed in the screw-in headers.]]
+
[[File:EPFL-relay_schematic.jpg|thumb|left|150px|How the solenoids are switched between ground and 24 V by the relays. Only shown for four relays; our setup has twelve connected identically.]]
 +
[[File:EPFL-EasyDAQ.jpg|thumb|left|150px|The EasyDAQ: 24 USB-controlled relays. The relays are connected to the PCB just by wires fixed in the screw-in headers.]]
== Complete parts list ==
== Complete parts list ==

Revision as of 12:35, 23 October 2011