Team:Yale/Protein

From 2011.igem.org

(Difference between revisions)
 
(3 intermediate revisions not shown)
Line 8: Line 8:
<p>All samples were successfully over-expressed in both BL21 and Origami cells. Expression was readily detected by SDS-PAGE and/or Western blotting. Some expression was also noted in the uninduced sample; this likely resulted from leaky expression of the T7 RNA polymerase gene and is a normal occurrence for the BL21 strain. No toxicity effects were observed due to recombinant expression. Strains expressing GFP-fused RiAFP formed bright green pellets after centrifugation post-induction. Importantly, GFP-fused RiAFP was produced at concentrations of approximately 0.2 millimolar (approximately 150mg/mL). This is several orders of magnitude greater than the expression levels achieved with TmAFP, which were in the micromolar range. Most of the TmAFP was observed in an insoluble pellet fraction (verified by SDS-PAG). The nanodrop instrument was not sensitive enough to use UV-vis spectroscopy to determine the concentration of soluble protein; instead we used flourimetry to obtain a rough estimate. Flourometric measurements were recorded using Photon Technology International Flurometer. An excitation wavelength of 488nm and an emission scan from 500nm to 650nm were used to measure fluorescence. </p>
<p>All samples were successfully over-expressed in both BL21 and Origami cells. Expression was readily detected by SDS-PAGE and/or Western blotting. Some expression was also noted in the uninduced sample; this likely resulted from leaky expression of the T7 RNA polymerase gene and is a normal occurrence for the BL21 strain. No toxicity effects were observed due to recombinant expression. Strains expressing GFP-fused RiAFP formed bright green pellets after centrifugation post-induction. Importantly, GFP-fused RiAFP was produced at concentrations of approximately 0.2 millimolar (approximately 150mg/mL). This is several orders of magnitude greater than the expression levels achieved with TmAFP, which were in the micromolar range. Most of the TmAFP was observed in an insoluble pellet fraction (verified by SDS-PAG). The nanodrop instrument was not sensitive enough to use UV-vis spectroscopy to determine the concentration of soluble protein; instead we used flourimetry to obtain a rough estimate. Flourometric measurements were recorded using Photon Technology International Flurometer. An excitation wavelength of 488nm and an emission scan from 500nm to 650nm were used to measure fluorescence. </p>
<p>The fact that we were able to achieve the first ever large-scale recombinant production of an insect antifreeze protein is significant. Inability to produce insect antifreeze proteins in large quantities without the use of expensive refolding protocols has been a limiting factor for their use in industry. We believe that RiAFP, which already has one of the highest thermal hysteresis activities of all known antifreeze proteins, is thus an attractive reagent to be used in industrial applications requiring freeze resistance. </p>
<p>The fact that we were able to achieve the first ever large-scale recombinant production of an insect antifreeze protein is significant. Inability to produce insect antifreeze proteins in large quantities without the use of expensive refolding protocols has been a limiting factor for their use in industry. We believe that RiAFP, which already has one of the highest thermal hysteresis activities of all known antifreeze proteins, is thus an attractive reagent to be used in industrial applications requiring freeze resistance. </p>
 +
</div>
 +
<div id="container">
 +
<h1>Novel Purification Method: Ice-Affinity Purification</h1>
 +
<p>Based on AFPs' active property of selectively binding to nascent ice crystals to disrupt crystalline structure, a protocol was adapted from Davies, et al to take advantage of this property to purify AFPs by slowly growing layers of ice on a cold finger in a solution of crude cell lysate.  The following figure below (image credits to Peter L. Davies lab at Queens' University: http://pldserver1.biochem.queensu.ca/afp/afp.shtml) demonstrates this process.<br /><br />
 +
 +
<img src="https://static.igem.org/mediawiki/2011/thumb/4/4e/Yale-IAFP.png/560px-Yale-IAFP.png" style="margin:auto; display:block" />
 +
<br />
 +
This ice affinity purification method is generalizable beyond purifying just AFPs, as it has been demonstrated that fusion proteins of GFP, MBP, and other proteins bound to AFPs have also been recoverable, making this a clever, inexpensive, yet sensitive and pure method of obtaining protein from a crude lysate.</p>
 +
As Ni-NTA columns are frequently prohibitively expensive for iGEM teams to complete protein purification, our AFP BioBrick parts subsequently have an added, extremely useful functionality of serving as fusion proteins for purification.  In addition, we have designed and machined cold fingers - the necessary hardware component to seed layered AFP-ice growth - and have included below diagrams of our CAD designs for future iGEM teams:
 +
<img src="https://static.igem.org/mediawiki/2011/b/b7/Yale-ColdFinger.png" style="margin-top:10px; margin-left:auto; margin-right:auto; display:block;" />
</div>
</div>
<div id="container">
<div id="container">

Latest revision as of 14:41, 28 October 2011

iGEM Yale

Protein Expression and Purification

All constructs were over-expressed in either the BL21*(DE3) strain or the Origami 2 (DE3) plyS strain. An aliquot of the origami strain was kindly provided by the Xiong Lab. This strain has mutations in both the thioredoxin reductase and glutathione reductase genes, which greatly enhance disulfide bond formation in the E. coli cytoplasm. Cell cultures were grown to OD ~0.5 and then induced by addition of 0.5mM-1mM IPTG. Several temperatures and length of induction were investigated to optimize yields. TmAFP cultures were lowered to 16oC and shaken for a further 40-48 hours. RiAFP cultures were lowered to 22oC and shaken overnight.

Cells were spun down at 4700rpm for 20 minutes. Pellets were resupended in lysis buffer, sonicated, and centrifuged once more. Protein samples were electrophoresed on a gradient 4% to 20% SDS-PAGE. Gels were either stained with Coomassie blue or were transblotted onto nitrocellulose membrane with Invitrogen iBlot Dry Blotting. Western blotting was performed according to manufacturer’s protocol, using mouse α-GFP-IgG2a antibody and rabbit α-his antibody (Santa Cruz). More details for this and all other protocols can be found in our “protocols” section.

The HisTrapTM purification column was used to purify the RiAFP recombinant protein. The agarose beads of the column were equilibrated with lysis buffer. Lysed samples were filtered through a 0.22uM filter and passed through the column. Fractions were eluted with an imidazole gradient. Fractions were over-loaded on a gel to check for purity, and pure fractions were combined and concentrated using a 10K molecular weight cutoff filter. For the purification of RiAFP, fusion protein samples were incubated overnight with TEV protease. Size exclusion chromatography was used to isolate RiAFP from the fusion protein. For crystallography purposes, size exclusion chromatography was used to obtain exceptional purity of RiAFP and RiGFP samples. Concentrations of purified protein were measured using a nanodrop A280, a Bradford Assay, and/or UV-vis spectroscopy.

All samples were successfully over-expressed in both BL21 and Origami cells. Expression was readily detected by SDS-PAGE and/or Western blotting. Some expression was also noted in the uninduced sample; this likely resulted from leaky expression of the T7 RNA polymerase gene and is a normal occurrence for the BL21 strain. No toxicity effects were observed due to recombinant expression. Strains expressing GFP-fused RiAFP formed bright green pellets after centrifugation post-induction. Importantly, GFP-fused RiAFP was produced at concentrations of approximately 0.2 millimolar (approximately 150mg/mL). This is several orders of magnitude greater than the expression levels achieved with TmAFP, which were in the micromolar range. Most of the TmAFP was observed in an insoluble pellet fraction (verified by SDS-PAG). The nanodrop instrument was not sensitive enough to use UV-vis spectroscopy to determine the concentration of soluble protein; instead we used flourimetry to obtain a rough estimate. Flourometric measurements were recorded using Photon Technology International Flurometer. An excitation wavelength of 488nm and an emission scan from 500nm to 650nm were used to measure fluorescence.

The fact that we were able to achieve the first ever large-scale recombinant production of an insect antifreeze protein is significant. Inability to produce insect antifreeze proteins in large quantities without the use of expensive refolding protocols has been a limiting factor for their use in industry. We believe that RiAFP, which already has one of the highest thermal hysteresis activities of all known antifreeze proteins, is thus an attractive reagent to be used in industrial applications requiring freeze resistance.

Novel Purification Method: Ice-Affinity Purification

Based on AFPs' active property of selectively binding to nascent ice crystals to disrupt crystalline structure, a protocol was adapted from Davies, et al to take advantage of this property to purify AFPs by slowly growing layers of ice on a cold finger in a solution of crude cell lysate. The following figure below (image credits to Peter L. Davies lab at Queens' University: http://pldserver1.biochem.queensu.ca/afp/afp.shtml) demonstrates this process.


This ice affinity purification method is generalizable beyond purifying just AFPs, as it has been demonstrated that fusion proteins of GFP, MBP, and other proteins bound to AFPs have also been recoverable, making this a clever, inexpensive, yet sensitive and pure method of obtaining protein from a crude lysate.

As Ni-NTA columns are frequently prohibitively expensive for iGEM teams to complete protein purification, our AFP BioBrick parts subsequently have an added, extremely useful functionality of serving as fusion proteins for purification. In addition, we have designed and machined cold fingers - the necessary hardware component to seed layered AFP-ice growth - and have included below diagrams of our CAD designs for future iGEM teams:

Figures

Figure 1: SDS-PAGE stained with Coomassie blue; uninduced eGFP-TmAFP (left), induced eGFP-TmAFP (right)
Figure 2: Western Blot, probed with His-6 antibody; uninduced eGFP-TmAFP (left), induced eGFP-TmAFP (right)
Figure 3: Western Blot, probed with eGFP antibody. Lane 0: ladder, Lane 1: uninduced eGFP-RiAFP in BL21, Lane 2: induced eGFP-RiAFP in BL21, Lane 3: uninduced eGFP-RiAFP in Origami, Lane 4: induced eGFP-RiAFP in Origami, Lane 5: uninduced RiAFP in BL21, Lane 6: induced RiAFP in BL21, Lane 7: uninduced RiAFP in Origami, Lane 8: induced RiAFP in Origami, Lane 9: uninduced eGFP-TEV-TmAFP, Lane 10: induced eGFP-TEV-TmAFP, Lane 11: ladder
Figure 4: Sample image of fractions collected after His-purification of RiAFP-GFP
Figure 5: Ri-AFP-GFP (HisTrap)
Figure 6: Treatment of RiAFP-GFP fusion protein with TEV protease
Figure 7: Purified RiAFP isolated post size exclusion. Cleaved GFP-TEV and GFP-TEV-RiAFP also visible on gel.