Team:Glasgow/Biofilm/Nissle

From 2011.igem.org

Revision as of 00:07, 22 September 2011 by Ellin (Talk | contribs)

E. coli Nissle 1917 - A novel biofilm-forming chassis

When the team began thinking about our project in May, we decided that it would be interesting to work with biofilm forming bacteria, however, we encountered several problems before we were able to start measuring the effect of our biobricks.

Firstly, we needed a repeatable method through which to form biofilms. As research in this area is relatively new, there are a large number of proposed methods available for growing biofilm. Unfortunately, many required specialised materials which we did not have access to or were prohibitively expensive. In the end, we developed a new protocol for growing biofilm based on a number of other protocols and the materials that we had available to us in the lab.

Next we required an assay through which to measure biofilm formation and dispersal. This required not only qualitative measurements (ie - has any biofilm formed at all?) but also in a manner which generates quantitative results. Again, other methods for this do already exist but were inaccessible to us because of cost or availability - because of this we generated a method for measuring formation and dispersal using the materials that we had available.

When we came to actually attempting to form biofilm we encountered another problem: many of the lab strains of E. coli have selectively lost their ability to form biofilm due to chromosomal deletions. Originally Pseudomonas aeruginosa was considered as a chassis, but it was quickly discarded as a majority of the biobricks available in the registry have already been optimised for use in E. coli. Whilst researching different strains of E. coli with the ability to form biofilm a member of our team came across the Nissle 1917 strain (Hancock, 2010). It has previously been documented on multiple occasions to be non-pathogenic, safe for human consumption and is commercially available as Mutaflor tablets in Germany. Being an E. coli strain, is was fully expected to be suitable for transformation with the majority of standard biobricks

We obtained the cells from Gerhard Breves, Hanover Institute of Physiology, and succesfully extracted them from Mutaflor Tablets. The desired cells we selected using using MacConkey's agar.

E. coli Nissle 1917 Biofilms

To prove biofilm formation glass slides were put into 50ml tubes containing 20ml of LB broth. The LB covered around a third of the glass slide, this is the area where the biofilm would form. The LB was then inoculated with 20μl of fresh overnight culture of E. coli Nissle. These tubes were then left on a bench top shaker at room temperature for 24 and 48 hours. The glass slides were then removed and the biofilm was stained by standard gram stain method. Photographs were taked of the stained biofilms.

Biofilm formation was also confirmed by SEM pictures that showed the extracellular matrix, such as Picture 1 below.

Picture 1: SEM image of Nissle biofilm
showing the extracellular matrix

Picture 2: 400x A gram-stained 16-hour
E.coli Nissle biofilm

Picture 3: 100x A gram stained 16-hour
E.coli Nissle biofilm


The images below may show why E.coli Nissle has the biofilm forming that E.coli lab strains lack. In Picture 4 the fimbriae of Nissle are clearly visible. Since the E.coli lab strain in Picture 5 does not have them, they may be the reason E.coli Nissle 1917 are so adept at clinging to each other.

Picture 4: 10,000x SEM image of Nissle
showing the fimbriae

Image 2: 15,000x EM of E.coli for comparison.
No fimbriae or EPS is visible. (courtesy of Rocky Mountain Laboratories)


Once it had been shown that E.coli Nissle formed biofilms, a time series of biofilm formation was performed. The tubes containing the slides were left on the tabletop shaker for a set amount of time (time points ranged from 1hr to 24hrs). After the biofilm had grown its allotted time the glass slide was carefully removed and placed into a fresh 50ml tube with 25ml of LB (which completely covered the biofilm) and left to allow the bacteria to disperse for 1hr. The slide was then transferred to a fresh 50ml tube with 25ml of LB. The biofilm is scraped off using a spatula, and the resulting culture was vortexed for 1 minute to break up any residual chunks of biofilm. The culture containing the dispersed cells and the culture containing the broken-up biofilm were then plated in serial dilution to obtain an estimate of the number of cells in each culture.

Results showed that on average 48% of the cells within a biofilm will disperse once the biofilm is transferred into fresh media. The percentage dispersed was expected to be inversely correlated to the size of the biofilm, because a larger biofilm was expected to have a higher affinity for the cells it holds. However, the data shows that the percentage dispersed is relatively constant, and varies between 30-60% dispersal.

The results are shown below.

Graph of percentage dispersal from biofilm

Graph 1: The total percentage of cells dispersed when a biofilm is transferred into new media vs time in hours

The data also showed that over time the amount of cells firmly within a biofilm increases at a similar rate to those that disperse and are not attached to the biofilm.

Cell count of biofilm and planktonic cells vs time

Graph 2: The estimated number of dispersed cells compared to the number of biofilm cells vs time in hours

View the full spreadsheet of E.coli Nissle 1917 dispersal here


Transforming Nissle

Chemically and Electrically competent E. coli Nissle cells were made and successfully transformed with RFP. Electroporation was notably more efficient than any chemical transformation. Problems were caused by the cells' tendency to clump together, which we assume is caused by their long fimbriae that were visible on the SEM pictures. this problem can be countered by either vortexing or sonicating the culture before plating them. We expect sonication to be the more efficient method.

The transformed E.coli Nissle cells showed expression of RFP, in culture and within a biofilm, proving that they can express standard E.coli constructs. The results can be seen in Pictures 4 through 6 below.

Picture 4: RFP transformed E.coli Nissle
overnight culture

Picture 5: A 24-hour biofilm of RFP
E.coli Nissle

Picture 6: Streaked RFP transformed
E.coli Nissle

Unfortunately we were unable to transform the Nissle cells with our novel biobricks due to time constraints, and were therefore unable to operate our synthetic system within the biofilm.


Nissle on the Registry

Since Nissle have proven to be transformable, and have distinct biofilm-forming abilities we have made the cells available to the Registry as a novel chassis for use in further research and projects involving biofilms.

Go back to P. aeruginosa

Go back to Biofilms

Reference

Hancock, V., Dahl, M. & Klemm, P., 2010. Probiotic Escherichia coli strain Nissle 1917 outcompetes intestinal pathogens during biofilm formation.Journal of Medical Microbiology. Vol 59, Jan 2010 pp 392-399.