Team:KIT-Kyoto/ぷろとこる英語
From 2011.igem.org
いんぐりっしゅ!
LB medium(LB培地)
bacto tryptone | 10 g |
bacto yeast evtract | 5 g |
NaCl | 10 g |
↓Dissolve appropriate amounts of (bacto tryptone and bacto yeast extracts)with the deionized water (See Table)
↓Sterilize it by autoclave at 121°C for 20 minutes.
LB plate(LBプレート)
LB medium | |
bacto-agar | 15 g/l |
↓Add 15g of bacto-agar to 1L of LB medium then sterilize it by autoclave.
↓If necessary, the antibiotics can be added after the temperature of LB-agar become below 65°C.
↓Twenty to twenty-five ml of LB-agar should be poured to the disposable sterilized dishes.
Transformation(トランスフォーム)
↓Dissolve the competent cells on ice
↓Prepare some iced 1.5ml tubes and pour competent cells for 100µl into the tubes.
↓Add 1~5µl of DNA solution to the 100µl of competent cells, then incubate for 30 minutes on ice.
↓Heat shock for 45 seconds at 42°C.
↓Add 900 µl of soc medium into each tube.
↓Incubate with shaking at 37°C for 1 hour.
↓Then spread on the LB plate containing an appropriate antibiotic.
↓Incubate at 37°C for 16 hours
Alkali SDS(アルカリミニプレップ)
↓Spread E.coli onto the LB plate (+amp),and incubate it at 37°C(API2-MALT1 for 30°C) for 16 hours.
↓Pick up the single colony from the plate.
↓Incubate it into the 2ml LB medium, and shake the tubes at 37°C(API2-MALT1 for 30°C) for hours.
↓Harvest the bacterial cells by centrifugation at 4°C for 5 minutes (5,000 x g).Discard the supernatant.
↓Add 100µl of iced SolutionⅠ to the tubes,and mix them using vortex.
↓Add 200µl of iced SolutionⅡ to the tubes,and mix them sharply not using vortex.
↓Let them stand on ice for 5 minutes.
↓Add 150µl of iced Solution Ⅲ to the tubes,and mix them sharply but not using vortex.
↓Let them stand on ice for 5 minutes.
↓Centrifuge them at 4°C for 10 minutes (12,000 x g).
↓Transfer supernatant into the tubes.
↓Add 450µl of Isopropanol and mix them well.Let them for 15 minutes.Then recover the DNA by centrifugation at 12,000 x g for 30 minutes at 25°C.
Ligation
Refer to following table, prepare a reaction solution.
insert | 0.5 µl |
vector | 0.5 µl |
2 x Buffer | 2.5 µl |
T4 ligase | 0.5 µl |
H2O | 1.0 µl |
total 5 µl |
Incubate it for 30min at 16 ℃.
・PCR
Add all reagents in a PCR tube.
Based on primers, set an appropriate annealing temperature.
・アガロース電気泳動
↓Prepare a 1% (w/v) agarose gel.
↓Add 10 µl of 6x loading dye to each 50 µl of digested solutions.
↓Load each of 60 µL samples and DNA maker in wells.
↓Run at 50 V and 60min.
↓Stain in EtBr solution for 10min.
・コンピ
↓Streak E.coli on LB plate and incubate for 16h.
↓Pick a single colony up, transfer it into 250 ml of SOB medium in a flask. Incubate it at
18°C with shaking.
↓When it reaches an OD600 of 0.4 to 0.8, transfer it on an ice for 10 min.
↓Harvest cells by centrifugation(4.5 x 103 g) for 10min at 4°C.
↓Remove the supernatant and resuspend the cells in 84 ml of ice-cold TB.
↓Keep it on ice for 10min.
↓Harvest cells by centrifugation(5 x 103 g) for 10min at 4°C.
↓Remove the supernatant and resuspend the cells in 40 ml of ice-cold TB.
↓Add 1.5 ml of DMSO(7%) and keep it on ice for 10min.
↓Pour each of 220 µl into chilled eppendorf tubes. Make sure to close tightly and then flash