Team:Grenoble/Projet/Results/rmsA
From 2011.igem.org
Characterisation of the RsmA post-transcriptional regulation system components
Justification of the need of a regulation system
In our project, we developed a translation regulation system in order to keep the system OFF until the pollutant is added. With modelling, we show that this system is really important and without it, the measure is really disturbed.
In all of our simulation, we considered the initial concentrations of both repressors equal to zero. This will be the case with the regulation system. Without this system, the initial concentrations of the repressors are higher. In the following figure, we performed a simulation for an aTc concentration of $1.10^{-6}$ with initial concentrations equal to zero and one with initial concentrations equal to $5\%$ of the concentrations in the steady state of the previous simulation.
![](https://static.igem.org/mediawiki/2011/3/36/RMSa_proof.png)
When the regulation system doesn't work, the interface is not at the place it supposed to be. Because we can't havemeasures of the initial concentration of both repressors, to well predict where the interface will appear, we need to control these concentrations. That's why we developed the translation regulation system.
Can rsmA be transferred into E. coli?
The RsmA system from Pseudomonas has a homologue in Escherichia coli, named "CsrA". We know that these two systems are extremely similar. Consequently we ask ourselves whether the synthesis of RsmA in E. coli interferes with its survival. Figure 1 shows growth curves of E.coli cells transformed by a plasmid containing an IPTG-inducible rsmA sequence from Pseudomonas and control cells carrying the same plasmid without rsmA. The superimposed curves demonstrate that the synthesis of RsmA does not interfere with the growth of E. coli.
![](https://static.igem.org/mediawiki/2011/7/7b/Grenoble_growth_curve.png)
Characterisation of the leader sequences
We cloned several leader sequences that contain a ribosome-binding site (RBS) in front of a reporter gene, GFP, in order to:
- Characterise their RBS strength
- Use them for the translational control of downstream genes by the RsmA/rsmY system.
![figure2](https://static.igem.org/mediawiki/2011/1/1a/Contructions_test.png)
We used a FACSCalibur flow cytometer to measure the GFP fluorescence emitted by cells containing the constructs shown in Fig.3. Two negative controls were set up: a brick having the GFP reporter gene but no promoter ( BBa_E0840 ) and a cell culture containing no plasmid.
50 μl of LB containing cells were diluted into 500 μl of filtered PBS (OD600 of inoculum was 3± 0,3 for all samples) and then introduced into the FACS ten minutes after dilution.
The cytometer counts each particle that passes through the light beam. Therefore it is necessary to select an analysis window that corresponds to the size of the bacteria (see Fig. 3).
![](https://static.igem.org/mediawiki/2011/4/49/Population_cell.png)
We then analysed the basal fluorescence recorded from control bacteria expressing no GFP. This allows to define two windows: the M1 window referring to basal fluorescence levels and containing fluorescence values obtained for all negative controls; the M2 window comprising fluorescence signals that are greater than the basal level. We show for each construction the average fluorescence (in red) within the window that contains most of the cells (percentages indicated in black, see Fig. 5).
![](https://static.igem.org/mediawiki/2011/d/d8/Facs_result_for_each_fha_system_constructs.png)
The two negative controls (cells containing no plasmid (1) or plasmid without promoter (2)) show a basal fluorescence signal as expected. Cells containing the reference brick BBa_K25003 (5) show a maximum amount of GFP fluorescence with 77 % of the cell population that fluoresce more than the negative controls. The average fluorescent signal calculated for construct 5 is 1030 (vs 2,5 (neg control)). The fluorescence signal obtained with cells containing the brick with the maga leader sequence (3) does not differ very much from the negative controls (4,4 vs 2,5). Four per cent of this cell population fluoresces more than the negative control populations.
90 % of cells containing the fha leader sequence (4) present a fluorescence signal that is higher than control cells. Their average fluorescence is 98.
Figure 6 summarises the cytometry results. We can see that both leader sequences mag and fha allow the translation of the gfp mRNA. They can therefore be used for further characterisation of the system. The GFP fluorescence signal is much higher using the fha leader sequence when compared to mag. Figure 7 focuses on the RBS strength of those two gene leader sequences, and compares them to the strongest RBS of the part registry: BBa_0034. Mag has got very week RBS binding site strength, whereas fha is stronger (10% of the maximum value obtained for BBa_0034).
Effect of rsmA and rsmY on the mag and fha reporter genes
After having established the RBS strength of fha and mag leader sequences using the GFP reporter gene constructs, we quantified the translational inhibition effect of the RsmA protein and the relieve of this inhibition in presence of the rsmY RNA. In order to do these experiments, E. coli cells were co-transformed with a combination of 3 different plasmids containing:
-
A leader sequence or the reference RBS upstream of GFP (constructs 3, 4 and 5 on Fig. 4)
-
A leader sequence or RBS plus an other plasmid containing rsmA (figure 7)
-
A leader sequence or RBS plus rsmA plus rsmY (figure 7)
The GFP fluorescence obtained from the constructs with fha, mag and reference RBS were analysed in the absence of RsmA and rsmY (single transformants) in the presence of RsmA (double transformants) and in the presence of both RsmA and rsmY (triple transformants). Note that in our experiments rsmA and rsmY were constitutively expressed because the repressors LacI and TetR were absent from our strains.
As expected, no inhibitory effect of RsmA was observed when the reference RBS ( BBa_0034 ) was used as this leader sequence does not have a binding site for RsmA (data not shown).
In contrast, RsmA decreased the GFP fluorescence level when mag or fha leader sequences were provided upstream of GFP and this decrease could be partially relieved in the presence of rsmY for fha (Figs 8 and 9).
Effect of rsmA and rsmY on fha-GFP constructs
Perspectives
So far only the characterisation of the leader sequences has been completed. Fha allows a better expression of GFP than mag.The next experiment will be to look at how these leader sequences react to the presence of the RsmA protein.
We did a few tests with ptet rsma and pcons-fha-gfp or pcons-mag-gfp. The first result showed an extremely low gfp signal, which suggests a repressive effect of Rsma on fha and mag. We cannot conclude yet because some controls are lacking. This however gives very promising prospects.
![]() iGEM 2011 Main Page Contact Us:Clic here ! |
![]() |