Team:Tsinghua-A/Modeling
From 2011.igem.org
Modeling Section
Overview | Accurate Model | Simplified Model | Dimensionless Model | Quorum-sensing Effect | Reference
PART 0 Intro
In our project, we are dedicated to design a quorum-sensing oscillator which consists of two types of cells. Cells of the same type can fluctuate synchronously and certain designs were made to adjust the phase and the amplitude of oscillation. These are the things that our modeling part aims to simulate. We built and simplified our simulation system step by step and deepened into further characteristics of the system, which would provide firm evidence proving that our design does work.
PART 1 Accurate Model
construction | parameters | results
In our first step, we wanted to describe the system thoroughly without leaving out any seemingly unimportant actions and factors. As a result, the description of the system contains every possible mass actions as well as some hill kinetics, Henri-Michaelis-Menten. We came up a set of ODEs with 19 equations.
PART 2 Simplified Model
preparation | parameters | results
Although ODEs provide a thorough, precise description of the whole system, they contain too many equations and parameters which would act as a barrier for simulation and further analysis. A simplification of complicated ODEs is necessary. We simplify every single ODE according to certain appropriate assumptions. Finally, we came up with a set of DDE equations.
PART 3 Dimensionless Model
preparation | parameters | results
In order to make a further analysis on stability of the system, sensitivity of parameters, feedback factors-we manipulate all the arguments and parameters to make them dimensionless. Analysis of this part is crucial since parameters in vivo experiment may be different and even at odds with modeling ones but a proper dimensionless can reveal the mathematical essence of our model.
PART 4 Quorum-sensing Effect
What we have done insofar is focused on two-cell oscillation. Quorum-sensing oscillator is not simply a matter of expansion in magnitude, but a matter of robustness in allowing difference of each individual cell. Moreover, we test the adjustment of phase and amplitude of oscillation in this part.
PART 5 Reference
Quick Overview
In our project, we designed
a quorum-sensing oscillator which consists of two types of cells. The
expression of the reporter genes (GFP of one cell type and GFP of another) of
the cells of the same type can fluctuate synchronously and certain designs were
made to adjust the phase and the period of oscillation.
To understand the property
of our system, we built a mathematical model based on ODEs (Ordinary Differential
Equations) and DDEs (Delayed Differential Equations) to model and characterize
this system. The simulation results helped us to deepened
into further characteristics of the system.
l Original full
model
Firstly
we wanted to describe the system thoroughly without leaving out any seemingly
unimportant actions and factors. As a result, the description of the system
contains every possible mass actions as well as some hill kinetics, Henri-Michaelis-Menten kinetics, and
the parameters were got from literature. The model was represented and
simulated in the Matlab toolbox SIMBIOLOGY. We listed
all 19 ODEs in the attached pdf file, you can
see more details there.
l Simplified DDE
model:
The original model contains
too many factors for analyzing the general property of system. To understand
the essential characters of the oscillator, we simplify the original model
according to certain appropriate assumptions, like Quasi-equilibrium for fast
reactions.
After series of derivation
based on those assumptions (see the attached pdf
file), we came up with the following set of DDEs (Delay Differential Equations)
We
coded the system by DDE description in MATLAB and did simulation analysis
accordingly. The result showed that the system could oscillate under certain parameters .
To further understand what
parameters could make the system oscillate, we did bifurcation analysis on the
Hill parameters. What we had to do was find the critical points where the
system can nearly oscillate but a little disruption may lead to a steady state
like that:
Depicting all those
critical points, as shown in the figure, the system could oscillate when cellB’s Hiill parameters were
located in the area named ‘Bistable’.
By adjusting certain
parameters, we saw that the oscillation’s period and phase could be controlled
properly, which is the most impressive character of our system. Here we present
a figure that the oscillation phase was adjusted by adding araC,
which could induce the pBad promoter, in cell type B.
After adding araC to our system at certain time, the
oscillation was interrupted at beginning, but could gradually recovered and finally, the phase was changed.
l Analysis based
on dimensionless model:
In
order to make a further analysis on stability of the system, and sensitivity of
parameters, we further simplified the model to make them dimensionless. In addition, we
tried to introduce feedback to our system and made a brief analysis on
different types of feedback we introduced.
l Population effect:
What we have analyzed so far
is focused on two-cell oscillation. Quorum-sensing oscillator is not simply a matter
of expansion in magnitude, but a matter of robustness in allowing difference of
each individual cell. Moreover, we test the adjustment of phase and period of
oscillation in this part.
As we all know, no two
things in this world are exactly the same, so do cells. The major differences
between individual cells that we take into consideration include:
● Each cell’s activity of promoter is varied, so each cell has
different rate to generate AHL.
● The initial amount of AHL
may be disproportionally distributed among cells.
The rate of generating AHL
is closely related to parameter and. Therefore, we
introduce randomness to both parameters by letting them
obey normal distribution, that is:
n(i) =+ N();
are the average
ability of generating 30C6HSL and 3012CHSL, and normal distribution-- N()--describes the
fluctuations of AHL generating rate in individual cell. We then expanded our
equations from 2 cells to a population of cells. Each cell share a mutual
environment in which we assume that AHLs in environment is proportionally distributed.
The figures indicate that
our system can oscillate synchronically being able to tolerate differences at
certain range among a population of cells.
We also tested whether the
oscillation is dependent on initial distribution of AHL by changing the initial
amount drastically by letting them follow uniform distribution. That is:
Initial(i) = unifrnd(0,20);
Based on this distribution
restraining the initial AHL concentration in each cell, we simulated out a
figure as follows.
The results demonstratively
give evidence proving that our system can start to oscillate synchronically
given variant initial starting status.
Reference
Uri
Alon, (2007). Network motifs: theory and experimental
approaches. Nature.
Chunbo Lou, Xili Liu, Ming Ni, et al. (2010). Synthesizing
a novel genetic sequential logic circuit: a push-on push-off switch. Molecular Systems Biology.
Tal
Danino, Octavio Mondragon-Palomino, Lev Tsimring & Jeff Hasty (2010). A synchronized quorum of genetic clocks. Nature.
Marcel
Tigges, Tatiana T. Marquez-Lago,
Jorg Stelling & Martin Fussenegger (2009). A
tunable synthetic mammalian oscillator. Nature.
Sergi Regot, Javio Macia
el al. (2010). Distributed biological computation with
multicellular engineered networks. Nature.
Martin Fussenegger, (2010). Synchronized bacterial clocks. Nature.
Andrew
H Babiskin and Christina D Smolke,
(2011). A synthetic library of RNA control modules for predictable tuning of
gene expression in yeast. Molecular Systems Biology.
Santhosh
Palani and Casim A Sarkar, (2011). Synthetic conversion
of a graded receptor signal into a tunable, reversible switch. Molecular Systems Biology.
Nancy
Kopell, (2002). Synchronizing
genetic relaxation oscillation by intercell
signaling. PNS