• Check the YFP expression of 5ml(shaking) and 15ml(water bath). No yellow fluorescent cells,
Aug.14th
Sunday
• Transform: the Gibson assembly results.
• Miniprep: 13K+10I
• Cut: 13K+10I
• Purification: the digestion results.
• Ligation: nirB+13K+10I
Week7
Day
Note
Aug.15th
Monday
• Plate: nirB+13K+10I
• Colony PCR: vgb+YFP+tetR +terminater
• Gibson PCR
Aug.16th
Tuesday
• Colony PCR: vgb+22M+10I, nirB+13K+10I
• No bands of 13K; 22M confirmed
Aut.17th
Wednesday
• Miniprep: 22M
• Cut: 22M
• Check CFP expression. No fluorescence.
Aug.18th
Thursday
• Transform: 13K, 10I, 22M, 12I, 18P
Aug.19th
Friday
• Miniprep: 13K, 10I, 22M, 12I, 18P
• Cut: 13K, 10I, 22M, 12I, 18P
• Run the gel
Aug.20th
Saturday
• Ligate 13K+10I, 22M+10I
Aug.21st
Sunday
• Transform: the Gibson assembly results.
• Miniprep: 13K+10I
• Cut: 13K+10I
• Purification: the digestion results.
• Ligation: nirB+13K+10I
Week8
Day
Note
Aug. 22nd
Monday
• Transform 13K+10I, 22M+10I
• Test new primers.
• PCR: 22M+10I, 13K+10I
• Run the PCR products.
• Cut the PCR products.
Aug. 23rd
Tuesday
• Test primers: CS/CP, VF/VR, pSB1_f/r
• Cut: 11P, 1F, 22M
• Run the cut results.1F-1/2/3 are right.
• Mix the 1F-1/2 purification products
• Cut: 1F-1+1F-2(E+S), 22M-3(X+P), pSB1C3(E+P)
Aug. 24th
Wednesday
Aug. 25th
Thursday
Aug. 26th
Friday
• Amplify: vgb, 1C3
Aug.27th
Saturday
• Digest: Vgb, 1C3, fdfhF, 22M+10I, 13K+10I
Aug.28th
Sunday
• Ligate: vgb+22M+10I, fdfhF+13K+10I
• Transform the ligation results.
1st August
Freeze slicing of about 50μm. Observe under natural light microscope and can see red
florescence. The thickness is about 130μm
4th August
Repeat the last experiment with silicone tube. 6rpm/s results in a flowing speed of 68ml/day
6th August
Similar to the last time. Did not use freeze slicing.
15th August
Cultured E.coli in 5ml LB for 12h.
16th August
Substituting a part of silicone tube with glass tube in silicone tube biofilm formation sets. Culture in
37℃
17th August
Add 50ml LB and culture with circular culture.
18th August
12.00 found one free-flow pump stopped. Cooled for 15 minutes and turned on again. Could be
over heated. Can see some bacteria on the bottom of the vessel and tube. When the pump started
again, the bacteria was washed away.
19th August
Can observe obvious white biofilm where the silicone tube joins the tube but cannot see red
florescence, suspect contamination. No biofilm is observed on the glass tube under microscope.
21st, August
Biofilm formation with large test tubes. Inoculate with 1% e.coli. Rubber tubes are attached to air
pump with filter between air pump and the tube to prevent entrance of germs. Two sets use MSM
+glucose medium and two sets use LB.
Retry with glass tube biofilm formation set.
24th, August
Terminate biofilm formation, the glass slide left in the drawer to dry. Can see obvious rod like
structure under 400 magnification. (spheres in MSM+glucose culture) No red florescence is seen.
Most of the surface is covered by single layer cells but some part of it has thick bump like
structure.
No biofilm observed on the glass tube.