Contents 1 Collaboration - Cell Viability in Tailings Pond Water 1.1 Materials and Methods 1.2 Results 1.3 Conclusion 2 Attributions & Contributions 2.1 Dr. A. William Smith 2.2 Mr. Doug Bray 2.3 Dr. Mark Roussel 2.4 Mr. David Lain Huston and the Arnott Labs 2.5 Others involved in bioSpirits film 2.6 Wet Lab Work

Collaboration - Cell Viability in Tailings Pond Water

We were asked by the Calgary iGEM team to to test the viability of their chassis to survive in tailings pond water. If E. coli DH5α cells containing one of their constructs can grow normally in medium prepared with tailings water, we can be confident that the chassis can be applied to tailings pond water in general.

Materials and Methods

50 mL of LB medium was made with tailings water and filtered through MILLEX filter Unit GS MF-Millipore MCE Membrane 0.22 µm in order to sterilize it and appropriate antibiotics were added. The tailings LB was inoculated with E. coli DH5α cells containing BBa_K331009 to an OD₆₀₀ of 0.1. The flask was incubated at 37˚C with shaking for 7 hours, during which photometric readings were taken every 30. Photometric readings were taken using the Pharmacia Biotech Ultrospec 3000, as the OD₆₀₀ readings reached 1.0 the solutions was diluted with LB media to keep the OD₆₀₀ reading between 0.1 and 1.0. The same protocol was used to observe cell growth of E. coli DH5α cells containing BBa_K331009 in 50 mL of LB medium made with MilliQ H₂O.

Results

Figure 1. OD₆₀₀ of E. coli DH5α cells containing BBa_K331009 cultured in LB medium made with tailings water (red) and LB medium made with MilliQ H₂O (black). Performed by our team.

Figure 2. OD₆₀₀ of E. coli DH5α cells containing BBa_K331009 cultured in LB medium made with tailings water (red and blue) and LB medium made with MilliQ H₂O (black). Performed independently by the Calgary 2011 Team.

Conclusion

As seen in Figure 1, E. coli DH5α cells were able to grow in LB medium made with tailings water, suggesting that the chassis will survive for use in tailings pond water.

Attributions & Contributions

The University of Lethbridge iGEM team would like to acknowledge the following people for their attributions and expertise which added to the success of our project, it is greatly appreciated, and has helped us gain new knowledge and skills.

Dr. A. William Smith

The Department of New Media at the University of Lethbridge – For his assistance, knowledge, leadership and hard work, in the Biospirits film project.

Mr. Doug Bray

The Faculty of Arts and Science at the University of Lethbridge – For his training and guidance of team members in the use of transmission electron microscopy.

Dr. Mark Roussel

The Department of Chemistry and Biochemistry at the University of Lethbridge – For his assistance with protein modeling.

Mr. David Lain Huston and the Arnott Labs

The Institute of Cellular, Molecular, and Systems biology in Glasgow – For sending the team genes from the Xylene degradation pathway.

Others involved in bioSpirits film

Members of the academic instructional community:

• Dennis Connally [Math]
• James Graham [New Media]

Students:

• Jeff Henry
• Zsuzsi Papp
• Jane Collin
• J.P. Pehl
• Colin McKague.

Community members:

• Two popular rock radio personalities: Vince and Rosie. [They interviewed Smith for their show.]
• Justin Alho [Elementary]
• Ryan Alho and Shayna FullerSmith [Middleschool]
• Sharra FullerSmith [Highschool]
• Christina Zehn
• Neal Alho
• Dan Lewis
• Ruth Connally
• Patricia MacNally

Wet Lab Work

We are proud to say that all wet lab work was accomplished by the undergraduate members of our iGEM team.