Team:Grenoble/Projet/Intro

From 2011.igem.org

Revision as of 22:29, 21 September 2011 by Maxime.huet (Talk | contribs)

Grenoble 2011, Mercuro-Coli iGEM


The Project, Mercuro-Coli

Introduction :

With industries growth, wastes are accumulating and presence of pollutant and toxic products is becoming an international concern.

Our project is oriented in this problematic, Mercuro-Coli is a mercury biosensor which allows to detect and quantify mercury contained into polluted water. Intended to fieldwork studies, the device should be very easy to used :

  • Ideally, the device should be a plate carried into a packaging.
  • Once unpacked, the sample just has to be added.
  • Finally, the result would be given by a red strip : its presence testifying that the sample contains mercury and its position on the plate acquainting about the quantity.

Specifications :

At the beginning of the project, specifications were defined about the final device. To get a better understanding on how the device should run, those are going to be taken back step by step.

  • Operating living cell : E. Coli: BW 25 113
  • Only one type of bacteria :
  • Once our genetic circuit achieved, it will be introduce to our E. Coli strain. Newly obtained bacteria strain will be then spread on the plate forming a bacteria film on the top of it.

  • Comparative measure :

The comparative measure will be made by comparing mercury concentration to IPTG concentration. IPTG concentration will is the reference.

So, an IPTG gradient concentration will be made beforehand constituting our scale of quantification.

By adding uniformly the polluted sample, two different bacteria behaviors will come up depending on the predominant concentration :