Team:ZJU-China/rainbo-modeling-v1.html

From 2011.igem.org

Revision as of 16:14, 27 October 2011 by Tlytiger (Talk | contribs)

Rainbofilm modeling

Biofilm

Rainbofilm

Xfilm

Parts

Achievements

Tools

Modeling

This model is used for simulating the behavior of our genetic circuits

Abstract

We will model our gene regulatory networks using Michaelis-Menten enzymatic kinetics,together with the usual rules of reaction kinetics. The resulting models, when spatial effects are neglected, are given in terms of ordinary differential equations describing the rate of change of the concentrations of gene products and proteins. A key component of all these models is the Hill function, used to describe the transcription phase. The presence of this highly nonlinear function, whilst accurately modeling the network, inevitably leads to restrictions on the analytical tools available to understand and predict the dynamics.

 

Model

Basic concepts and assumptions

The ODE formalism models the concentrations of RNAs, proteins, and other molecules by time-dependent variables with values contained in the set of nonnegative real numbers. Regulatory interactions take the form of functional and differential relations between the concentration variables. For a typical transcription-translation process, the ODEs modeling approach associates two ODEs with any given gene i; one modeling the rate of change of the concentration of the transcribed mRNA r_i, and the other describing the rate of change of the concentration of its corresponding translated protein p_i. Thus for our network with 3 genes we have:

function1-2

Where (1) describes transcription, (2) describes translation, and i = 1,…,N. The functions R_i(p_j) describe the dependence of mRNA concentration on protein concentration p_j (If protein p_j has no effect on mRNA r_i, then correspond function is set to zero.) The functional F(·) in (1) is defined in terms of sums and products of functions R_i. Function P_i in (2) describes the translation of the mRNA r_i into a protein p_i. Parameters γ_i, δ_i (i = 1,…,N), represent the degradation parameters of the mRNAs and proteins produced by gene i. As is common, we shall assume that the degradation of proteins or mRNAs is not regulated, namely that it does not depend on the concentrations of other molecules in the cell. Function R_i is assumed to be in the form of Hill function as usual (since our cases are all inhibitors, we shall denote the Hill function h-(p,K,n)), and the function P_i is taken to be a linear term proportional to the concentration of mRNA r_i.

function3

where K_i is the microscopic dissociation constant, and n_i is Hill coefficient, describing cooperativity.

Biobrick

 

Equations & Parameters

Based on the above, our model could be founded with following ODEs:

function4-10

Where

function11

 

Parameters

Variables are defined in following table.

parameters1 parameters2

We should note that α and β are two functions of the oxygen concentration, which are determined by the properties of corresponding promoter. For a certain depth of the biofilm, the concentration of oxygen is a constant in our model, so are and . Therefore we could solve these equations at different oxygen concentration and combine all the results to show how this system work.

Because of the nonlinearity of the Hill functions, the solutions of a system of ordinary differential equations of a network of many genes cannot generally be determined by analytical means.

Simulation

Equilibrium analysis

Notice that we care more about the final state of the bacteria in different depth of the biofilm(thus in different oxygen condition), we assume that the system has reached a steady state. We could calculus this steady state by setting all derivatives with respect to time to zero. That is, let

function12

 

 

With (4)-(10), we have:

function13

 

Clearly, the behavior of this system is determined by the two functions, thus determined by the behavior of promoter vgb & promoter fdhF. On the other hand, the solutions of equations The two functions αand β are hard to determine precisely, but their behavior could be illustrated in follow graph qualitatively.

case1

First case, When the expression of promoter vgb and fdhF could be neglected, that is, we could setαandβto be both zero. The ODEs system become

function20-23

The results are shown as follows

 

case2

Secondly,in the anaerobic condition, that is, when the expression of promoter vgb could be neglected, we setαto be zero, and setβto be bigger than the dissociation constant in (13). Then we have

function24-29

The results are shown as follow

  • 1
  • 2
  • 3

case3

Thirdly, since our ODEs model are symmetric respect to YFP & CFP in some sense, therefore the case of microaerobic (where we could setβto be zero) would be the same(symmetric) as in second case.

function30-35

Results

  • 1
  • 2
  • 3

 

Robustness analysis

Robustness is very important to a genetic circuit. Scientists hope their artificial system have high tolerance to the variety of environment or system parameters. In our genetic circuit, and are directly represent the properties of Vgb and Fdhf, so we are interested in to what degree these two parameters could influence the behavior of Ptet.

We could show the contribution of the two parameters and by fix one of them, and let the other one varies linearly. When fix at 1e-9, and changing from 0 to 1e-7 continuously, the production of each protein is shown in following graphs.

  • 1
  • 2
  • 3

 

Also, we could let both and to vary linearly (from 0 to 1e-11) to see how protein CFP changes. The actual curve with respect to depth of biofilm for CFP production is a curve on this surface.

robust4

 

Results

Combine Data acquired in part characterization and modeling of biofilm and biobrick, we can get the relationship between distribution of oxygen in the biofilm and the expression rate of CFP RFP YFP as follow:

YFP:

RFP:

From the fitting results we know that: The PoPS of YFP could be regard as zero since PPO of 10%, and approximately linearly increasing from 0% to 2.5%, and decreasing from 2.5% to 10%. The PoPS of RFP could be regard as zero since PPO of 2%, and approximately linear from 0% to 2%. Together with the results of former modeling sections, we could show the stratified biofilm in following graph.

 

Reference

[1]

J.B. Andersen et al., "New Unstable Variants of Green Fluorescent Protein for Studies of Transient Gene Expression in Bacteria," Applied and Environmental Microbiology, vol. 64, Jun. 1998, pp. 2240–2246.

[2]

Goryachev, A.B., D.J. Toh and T. Lee. "System analysis of a quorum sensing network: Design constraints imposed by the functional requirements, network topology and kinetic constant." BioSystems 2006: 83, 178-187.

[3]

Alon, Uri. "An Introduction to Systems Biology Design Principles of Biological Circiuts." London: Chapman & Hall/CRC, 2007.

[4]

David Braun et al. Parameter estimation for two synthetic gene networks: A case study. IEEE 2005.

[5]

Aberdeen_Scotland 2009. "Modeling Parameters" iGEM wiki.

[6]

Wilfried Weber, Markus Rimann, Manuela Spielmann, Bettina Keller, Marie Daoud-El Baba, Dominique Aubel, Cornelia C Weber & Martin Fussenegger, Gas-inducible transgene expression in mammalian cells and mice, Nature Biotechnology, volume 22, number 11, November 2004