Team:NTNU Trondheim/relA

From 2011.igem.org

(Difference between revisions)
m (relA)
m
Line 1: Line 1:
{{:Team:NTNU_Trondheim/NTNU_header}}
{{:Team:NTNU_Trondheim/NTNU_header}}
-
 
==relA==
==relA==

Revision as of 21:24, 30 August 2011


relA

In a previous study[1] the possible fuction of rrnB P1 in a biological containment system was investigated. ppGpp synthase (relA) was over-expressed to investigate the effect on the promoter. They showed that the expression was completely turned off when high amounts of relA was produced[1]. relA synthesizes ppGpp when an "empty" amino-acyl t-RNA binds the ribosome. However when it is over-expressed, ppGpp is produced at sufficient levels to inhibit rrnB P1.

We wanted to use relA to characterize ppGpp's effect on the rrnB P1 promoter. To use relA in our project, we had to amplify the gene from chromosomal DNA, as it was not found in the Partsregistry. Primers were designed as shown below, giving the full 2234 bp gene plus the [http://openwetware.org/wiki/Synthetic_Biology:BioBricks/Part_fabrication Openwetware prefix and suffix];


relA.fwd: GTTTCTTCGAATTCGCGGCCGCTTCTAGAGATGGTTGCGGTAAGAAGTGCACA

relA.rev: GTTTCTTCCTGCAGCGGCCGCTACTAGTACTAACTCCCGTGCAACCGACG


The gene was amplified from colony PCR, digested and inserted into digested linearized pSB1A3. The sequence of the gene + pre- and suffix is given in the textfile.

Nucleotide sequence of relA biobrick


NOTE: The gene contains a PstI site at bp 1393-1398. This could be removed with site-specific point mutagenesis, changing CTGCAG → CTACAG or CTGCAA. In our project, we avoided this problem by doing partial digestion in those steps where plasmids containing RelA had to be cut with PstI.


[1] Tedin, K., A. Witte, et al. (1995). "Evaluation of the E. coli ribosomal rrnB P1 promoter and phage-derived lysis genes for the use in a biological containment system: A concept study." Journal of Biotechnology 39(2): 137-148.