Team:Wageningen UR/Project/DevicesSetup

Setup

The main concern for the setup of the device was to be able to gain control over the flow rate. According to Bernoulli's principle, the velocity of a fluid can be influenced by varying the height of the medium bottle. This approach was also used in the paper cited above. Figure X. shows the corresponding setup and the applying equations.

Fig.X: Setup of the device using Bernoulli's principle to control the velocity of the fluid.

However, as mentioned on the modeling page, the dimensions of our fluidic device did not allow the aimed for precise control over the flow rate. This was tested both by calculating some theoretical values applicable for our device and running pilot experiments with water. Furthermore the obtained flow rates were also much faster than the flow rates in which oscillations were to be expected. This was solved by expanding our setup to incorporate the use of a syringe pump which controls the inflow. Figure X+1 shows the new setup.

Fig.X+1: Setup of the device using a pump to control the velocity of the fluid.

In order to be able to observe oscillations, the device was designed in such a way that it was possible to place it under a microscope for measuring GFP.

Top: Devices under the microscope

Right: Entire setup of the system around the fluorescence microscope

back to top